C8051F80X_14 Datasheet, PDF (232/251 Pages) Silicon Laboratories – Mixed Signal ISP Flash MCU Family

C8051F80x-83x
29.3.4. Frequency Output Mode
Frequency Output Mode produces a programmable-frequency square wave on the module’s associated
CEXn pin. The capture/compare module high byte holds the number of PCA clocks to count before the out-
put is toggled. The frequency of the square wave is then defined by Equation 29.1.
F_CEXn
=
---------------^F----^P---^C---^A---------------
2  PCA0CPHn
Note: A value of 0x00 in the PCA0CPHn register is equal to 256 for this equation.
Equation 29.1. Square Wave Frequency Output
Where F_PCA is the frequency of the clock selected by the CPS2–0 bits in the PCA mode register,
PCA0MD. The lower byte of the capture/compare module is compared to the PCA counter low byte; on a
match, CEXn is toggled and the offset held in the high byte is added to the matched value in PCA0CPLn.
Frequency Output Mode is enabled by setting the ECOMn, TOGn, and PWMn bits in the PCA0CPMn reg-
ister. The MATn bit should normally be set to 0 in this mode. If the MATn bit is set to 1, the CCFn flag for
the channel will be set when the 16-bit PCA0 counter and the 16-bit capture/compare register for the chan-
nel are equal.
Write to
PCA0CPLn
0
ENB
Reset
Write to
PCA0CPHn ^ENB
1
PCA0CPMn
PECCMT PE
WC A A A O WC
MO P P T GMC
1 MPN n n n F
6nnn
n
n
x 000
x
PCA0CPLn
Enable
8-bit
Comparator
8-bit Adder
PCA0CPHn
Adder
Enable
Toggle
match
TOGn
0 _{CEXn Crossbar}
1
Port I/O
PCA Timebase
PCA0L
Figure 29.7. PCA Frequency Output Mode
29.3.5. 8-bit through 15-bit Pulse Width Modulator Modes
Each module can be used independently to generate a pulse width modulated (PWM) output on its associ-
ated CEXn pin. The frequency of the output is dependent on the timebase for the PCA counter/timer, and
the setting of the PWM cycle length (8, 9, 10, 11, 12, 13, 14, or 15-bits). For backwards-compatibility with
the 8-bit PWM mode available on other devices, the 8-bit PWM mode operates slightly different than 9, 10,
11, 12, 13, 14, and 15-bit PWM modes. It is important to note that all channels configured for 8-bit
through 15-bit PWM mode will use the same cycle length. For example, it is not possible to configure
one channel for 8-bit PWM mode and another for 11-bit mode. However, other PCA channels can be con-
figured to Pin Capture, High-Speed Output, Software Timer, Frequency Output, or 16-bit PWM mode inde-
pendently.
232
Rev. 1.0