JN517X Datasheet, PDF(78/100 Page) NXP Semiconductors

English

English German Russian Spanish Italian Polish Chinese Japanese Korean French Portuguese	Language :

JN517X Datasheet, PDF (78/100 Pages) NXP Semiconductors – Supports multiple network stacks

◁

NXP Semiconductors

JN517x

IEEE802.15.4 Wireless Microcontroller

Table 36. Radio transceiver characteristics: ï40 ï°C â¦continued

VDD = 2 V to 3.6 V; unless otherwise specified.

Symbol Parameter

Conditions

Psp(RX)

receiver spurious power measured conducted into 50 ïï

30 MHz to 1 GHz

1 GHz to 12 GHz

PL(lo)

local oscillator leakage

power

IMP

intermodulation

protection

1 % PER at with wanted signal 3 dB above

sensitivity; modulated interferers at 3 and 6

channel separation

ïï¡RSSI

RSSI variation

ï95 dBm to ï10 dBm; available through

JN517x Integrated Peripherals API

Transmitter

Po(cr)

output power

control range output

power

PA = 5 and Att. 2.5 dB OFF

in 6 major steps and then 4 fine steps

Psp(TX)

transmitter spurious

power

measured conducted into 50 ïï

30 MHz to 1 GHz

1 GHz to 12.5 GHz (harmonic H2)

exceptions

1.8 GHz to 1.9 GHz

5.15 GHz to 5.3 GHz

EVM

error vector magnitude at maximum output power

EVMoffset error vector magnitude at maximum output power

offset

PSD

power spectral density relative density at greater than 3.5 MHz

offset

absolute density at greater than 3.5 MHz

offset

Min Typ Max Unit

ï70 dBm

ï54 dBm

[1] -

45 -

ï±4 -

[3]

[4] -

- 10 -

ï42 -

dBm

ï65 dBm

ï36 dBm

ï65 dBm

[5] -

ï38 -

dBc

[5] -

ï32 -

dBm

[1] Blocker rejection is defined as the value, when 1 % PER is seen with the wanted signal 3 dB above sensitivity, as per IEE802.15.4.

[2] Channels 11, 17, 24 low/high values reversed.

[3] To reach the maximum TX power, 2.8 V is the minimum on VDDA.

[4] Up to an extra 2.5 dB of attenuation is available if required.

[5] See IEEE802.15.4.

Table 37. Radio transceiver characteristics: +125 ï°C

VDD = 2 V to 3.6 V; unless otherwise specified.

Symbol Parameter

Conditions

Receiver

SRX

Pi(RX)(max)

receiver sensitivity

nominal for 1 % PER, as per 802.15.4

maximum receiver input 1 % PER, measured as sensitivity; supply

power

current at 14.8 mA; high-performance mode

1 % PER, measured as sensitivity; supply

current at 12.7 mA; low-power mode

Min Typ Max Unit

ï94 -

dBm

ï10 -

dBm

JN517X

Product data sheet

All information provided in this document is subject to legal disclaimers.

Rev. 2.0 â 8 November 2016

78 of 100

▷