JN517X Datasheet, PDF (65/100 Pages) NXP Semiconductors – Supports multiple network stacks

NXP Semiconductors
JN517x
IEEE802.15.4 Wireless Microcontroller
14. Characteristics
14.1 DC current
Table 16. Active processing
V_DD = 2 V to 3.6 V; T_amb = 40 C to +125 C; unless otherwise specified.
Symbol Parameter
Conditions
I_DD
supply current
CPU in doze mode; analog and digital
with radio in receive mode; maximum input
level at 10 dBm; high-performance mode
with radio in receive mode; maximum input
level at 2 dBm; low-power mode
with radio in transmit mode 10 dBm
with radio in transmit mode 8.5 dBm
with radio in transmit mode 3 dBm
without radio
CPU processing at:
32 MHz
16 MHz
8 MHz
4 MHz
2 MHz
1 MHz
I_DD(ADC) ADC supply current
I_DD(comp)
I_DD(UART)
I_DD(tmr)
I_DD(sintf)
comparator supply
current
operating mode
low-power mode
UART supply current per UART
timer supply current per timer
serial interface supply SPI-bus supply current
current
Min
[1]
-
-
[2] _-
[2] _-
-
-
[3]
-
-
-
-
-
-
[4] _-
[5]
[5]
-
-
[5] _-
[5] _-
[5] _-
Typ Max Unit
14.8 -
mA
12.7 -
mA
22.5 -
mA
19.6 -
mA
14
-
mA
2
-
mA
2.62 -
mA
1.54 -
mA
0.89 -
mA
0.49 -
mA
0.28 -
mA
0.15 -
mA
390 -
A
70
-
A
0.62 -
A
60
-
A
54
-
A
40
-
A
[1] Doze mode = CPU is not clocked.
[2] To reach the maximum TX power, 2.8 V is the minimum.
[3] Digital consumption only. When in CPU doze, the current related to CPU speed is not consumed. This value should be added to the
CPU in doze mode supply current value.
[4] Temperature sensor and battery measurements require ADC.
[5] These numbers should be added to I_DD if the feature is being used.
JN517X
Product data sheet
All information provided in this document is subject to legal disclaimers.
Rev. 2.0 — 8 November 2016
© NXP Semiconductors N.V. 2016. All rights reserved.
65 of 100