JN517X Datasheet, PDF (76/100 Pages) NXP Semiconductors – Supports multiple network stacks

NXP Semiconductors
JN517x
IEEE802.15.4 Wireless Microcontroller
Table 35. Radio transceiver characteristics: +25 C …continued
V_DD = 2 V to 3.6 V; unless otherwise specified.
Symbol Parameter
Conditions
Min Typ Max
P_i(RX)(max) maximum receiver input 1 % PER, measured as sensitivity; supply
power
current at 14.8 mA; high-performance mode
-
10 -
1 % PER, measured as sensitivity; supply
current at 12.7 mA; low-power mode
-
2 -
_ch
channel rejection
1 % PER, with wanted signal 3 dB, above sensitivity as per 802.15.4
modulated interferer^[1][2]
1 channel
-
19 -
+1 channel
-
34 -
2 channel
-
40 -
+2 channel
-
44 -
co-channel
-
7 -
CW interferer^[1][2]
1 channel
-
25 -
+1 channel
-
50 -
2 channel
-
57 -
+2 channel
-
60 -
_ib
in-band rejection
1 % PER with wanted signal 3 dB above
[1] _-
43 -
sensitivity; 2.4 GHz to 2.4835 GHz;
modulated interferers at 3 channel
separation
_oob
out-of-band rejection 1 % PER with wanted signal 3 dB above
[1]
sensitivity
all frequencies except wanted/2 which is
8 dB lower
-
45 -
3G frequency at 2.1 GHz
-
5 -
LTE frequency at 2.5 GHz
-
18 -
P_sp(RX)
receiver spurious power measured conducted into 50 
30 MHz to 1 GHz
-
-
70
1 GHz to 12 GHz
-
-
70
P_L(lo)
local oscillator leakage
power
-
-
55
IMP
intermodulation
protection
1 % PER at with wanted signal 3 dB above
[1] _-
sensitivity; modulated interferers at 3 and 6
channel separation
46 -
_RSSI
RSSI variation
95 dBm to 10 dBm; available through
JN517x Integrated Peripherals API
4 -
+4
Transmitter
P_o
P_o(cr)
output power
control range output
power
PA = 5 and Att. 2.5 dB OFF
in 6 major steps and then 4 fine steps
[3]
[4] _-
- 10 -
42 -
Unit
dBm
dBm
dBc
dBc
dBc
dBc
dBc
dBc
dBc
dBc
dBc
dBc
dBc
dBm
dBm
dBm
dBm
dBm
dB
dB
dBm
dB
JN517X
Product data sheet
All information provided in this document is subject to legal disclaimers.
Rev. 2.0 — 8 November 2016
© NXP Semiconductors N.V. 2016. All rights reserved.
76 of 100