JN517X Datasheet, PDF(77/100 Page) NXP Semiconductors

English

English German Russian Spanish Italian Polish Chinese Japanese Korean French Portuguese	Language :

JN517X Datasheet, PDF (77/100 Pages) NXP Semiconductors – Supports multiple network stacks

◁

NXP Semiconductors

JN517x

IEEE802.15.4 Wireless Microcontroller

Table 35. Radio transceiver characteristics: +25 ï°C â¦continued

VDD = 2 V to 3.6 V; unless otherwise specified.

Symbol Parameter

Conditions

Psp(TX)

transmitter spurious

power

measured conducted into 50 ïï

30 MHz to 1 GHz

1 GHz to 12.5 GHz (harmonic H2)

exceptions

1.8 GHz to 1.9 GHz

5.15 GHz to 5.3 GHz

EVM

error vector magnitude at maximum output power

EVMoffset error vector magnitude at maximum output power

offset

PSD

power spectral density relative density at greater than 3.5 MHz

offset

absolute density at greater than 3.5 MHz

offset

Min Typ Max Unit

ï65 dBm

ï36 dBm

ï65 dBm

4.5 %

[5] -

ï38 ï20 dBc

[5] -

ï32 -

dBm

[1] Blocker rejection is defined as the value, when 1 % PER is seen with the wanted signal 3 dB above sensitivity, as per IEE802.15.4.

[2] Channels 11, 17, 24 low/high values reversed.

[3] To reach the maximum TX power, 2.8 V is the minimum on VDDA.

[4] Up to an extra 2.5 dB of attenuation is available if required.

[5] See IEEE802.15.4.

Table 36. Radio transceiver characteristics: ï40 ï°C

VDD = 2 V to 3.6 V; unless otherwise specified.

Symbol Parameter

Conditions

Min Typ Max

Receiver

SRX

Pi(RX)(max)

receiver sensitivity

nominal for 1 % PER, as per 802.15.4

maximum receiver input 1 % PER, measured as sensitivity; supply

power

current at 14.8 mA; high-performance mode

ï96.5 -

10 -

1 % PER, measured as sensitivity; supply

current at 12.7 mA; low-power mode

ï2 -

ï¡ch

channel rejection

1 % PER, with wanted signal 3 dB, above sensitivity as per 802.15.4

modulated interferer[1][2]

ï1 channel

19 -

+1 channel

34 -

ï2 channel

40 -

+2 channel

44 -

co-channel

ï7 -

ï¡ib

in-band rejection

1 % PER with wanted signal 3 dB above

[1] -

43 -

sensitivity; 2.4 GHz to 2.4835 GHz;

modulated interferers at 3 channel

separation

ï¡oob

out-of-band rejection 1 % PER with wanted signal 3 dB above

[1] -

45 -

sensitivity; all frequencies except wanted/2

which is 8 dB lower

Unit

dBm

dBc

JN517X

Product data sheet

All information provided in this document is subject to legal disclaimers.

Rev. 2.0 â 8 November 2016

77 of 100

▷