MC68HC08AS32 Datasheet, PDF (363/394 Pages) Motorola, Inc – M68HC08 Family of 8-bit microcontroller units (MCUs)

Byte Data Link Controller-Digital (BDLC-D)
BDLC CPU Interface
NOTE:
The extra logic 1s are an enhancement to the J1850 protocol which
forces a byte boundary condition fault. This is helpful in preventing noise
from going onto the J1850 bus from a corrupted message.
TMIFR0 — Transmit Multiple Byte IFR without CRC (Type 3) Bit
The TMIFR0 bit is used to request the BDLC to transmit the byte in
the BDLC data register (BDR) as the first byte of a multiple byte IFR
without CRC. Response IFR bytes are still subject to J1850 message
length maximums (see 20.5.2 J1850 Frame Format and Figure
20-18).
1 = If this bit is set prior to a valid EOD being received with no CRC
error, once the EOD symbol has been received the BDLC will
attempt to transmit the appropriate normalization bit followed
by IFR bytes. The programmer should set TEOD after the last
IFR byte has been written into the BDR register. After TEOD
has been set, the last IFR byte to be transmitted will be the last
byte which was written into the BDR register.
0 = The TMIFR0 bit will be cleared automatically; once the BDLC
has successfully transmitted the EOD symbol; by the detection
of an error on the multiplex bus; or by a transmitter underrun
caused when the programmer does not write another byte to
the BDR after the TDRE interrupt.
If the TMIFR0 bit is set, the BDLC will attempt to transmit the
normalization symbol followed by the byte in the BDR. After the byte
in the BDR has been loaded into the transmit shift register, a TDRE
interrupt (see 20.7.4 BDLC State Vector Register) will occur similar
to the main message transmit sequence. The programmer should
then load the next byte of the IFR into the BDR for transmission.
When the last byte of the IFR has been loaded into the BDR, the
programmer should set the TEOD bit in the BCR2. This will instruct
the BDLC to transmit an EOD symbol once the byte in the BDR is
transmitted, indicating the end of the IFR portion of the message
frame. The BDLC will not append a CRC when the TMIFR0 is set.
If the programmer attempts to set the TMIFR0 bit after the EOD
symbol has been received from the bus, the TMIFR0 bit will remain in
the reset state, and no attempt will be made to transmit an IFR byte.
MC68HC08AS32 — Rev. 3.0
MOTOROLA
Byte Data Link Controller-Digital (BDLC-D)
Advance Information
363