MC68HC08AS32 Datasheet, PDF (285/394 Pages) Motorola, Inc – M68HC08 Family of 8-bit microcontroller units (MCUs)

Serial Peripheral Interface (SPI)
Transmission Formats
SCK CYCLE #
FOR REFERENCE
SCK CPOL = 0
SCK CPOL =1
MOSI
FROM MASTER
MISO
FROM SLAVE
SS TO SLAVE
CAPTURE STROBE
1
2
3
4
5
6
7
8
MSB
BIT 6
BIT 5
BIT 4
BIT 3
BIT 2
BIT 1
LSB
MSB
BIT 6
BIT 5
BIT 4
BIT 3
BIT 2
BIT 1
LSB
Figure 18-5. Transmission Format (CPHA = 1)
begins driving its MOSI pin on the first SPSCK edge. Therefore, the
slave uses the first SPSCK edge as a start transmission signal. The SS
pin can remain low between transmissions. This format may be
preferable in systems having only one master and only one slave driving
the MISO data line.
When CPHA = 1 for a slave, the first edge of the SPSCK indicates the
beginning of the transmission. This causes the SPI to leave its idle state
and begin driving the MISO pin with the MSB of its data. Once the
transmission begins, no new data is allowed into the shift register from
the transmit data register. Therefore, the SPI data register of the slave
must be loaded with transmit data before the first edge of SPSCK. Any
data written after the first edge is stored in the transmit data register and
transferred to the shift register after the current transmission.
MC68HC08AS32 — Rev. 3.0
MOTOROLA
Serial Peripheral Interface (SPI)
Advance Information
285