MC68HC08AS32 Datasheet, PDF (122/394 Pages) Motorola, Inc – M68HC08 Family of 8-bit microcontroller units (MCUs)

System Integration Module (SIM)
9.8 SIM Registers . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .140
9.8.1 SIM Break Status Register . . . . . . . . . . . . . . . . . . . . . . . .140
9.8.2 SIM Reset Status Register . . . . . . . . . . . . . . . . . . . . . . . .142
9.8.3 SIM Break Flag Control Register. . . . . . . . . . . . . . . . . . . .143
9.2 Introduction
This section describes the system integration module (SIM), which
supports up to 24 external and/or internal interrupts. The SIM is a system
state controller that coordinates CPU and exception timing. Together
with the central processor unit (CPU), the SIM controls all MCU
activities. A block diagram of the SIM is shown in Figure 9-1.
Table 9-1 is a summary of the SIM input/output (I/O) registers.
The SIM is responsible for:
• Bus clock generation and control for CPU and peripherals:
– Stop/wait/reset/break entry and recovery
– Internal clock control
• Master reset control, including power-on reset (POR) and
computer operating properly (COP) timeout
• Interrupt control
– Acknowledge timing
– Arbitration control timing
– Vector address generation
• CPU enable/disable timing
• Modular architecture expandable to 128 interrupt sources
Advance Information
122
System Integration Module (SIM)
MC68HC08AS32 — Rev. 3.0
MOTOROLA