|
PIC18F45K80-I Datasheet, PDF (548/622 Pages) Microchip Technology – 28/40/44/64-Pin, Enhanced Flash Microcontrollers with ECAN and nanoWatt XLP Technology | |||
|
◁ |
PIC18F66K80 FAMILY
31.2 DC Characteristics: Power-Down and Supply Current
PIC18F66K80 Family (Industrial/Extended) (Continued)
PIC18F66K80 Family
(Industrial/Extended)
Standard Operating Conditions (unless otherwise stated)
Operating temperature
-40°C ï£ TA ï£ +85°C for industrial
-40°C ï£ TA ï£ +125°C for extended
Param
No.
Device
Typ
Max Units
Conditions
Supply Current (IDD) Cont.(2,3)
PIC18LFXXK80
270
600 ïA
-40°C
270
600 ïA
270
600 ïA
300
700 ïA
+25°C
+60°C
+85°C
VDD = 1.8V(4)
Regulator Disabled
320
850 ïA
+125°C
PIC18LFXXK80
540
1000 ïA
-40°C
PIC18FXXK80
540
1000 ïA
540
1000 ïA
550
1100 ïA
560
1200 ïA
566
1020 ïA
585
1020 ïA
590
1020 ïA
595
1120 ïA
+25°C
+60°C
+85°C
+125°C
-40°C
+25°C
+60°C
+85°C
VDD = 3.3V(4)
Regulator Disabled
VDD = 3.3V(5)
Regulator Enabled
FOSC = 4 MHz
(PRI_RUN mode,
EC oscillator)
600
1220 ïA
+125°C
PIC18FXXK80
630
2000 ïA
-40°C
630
2000 ïA
630
2000 ïA
640
2000 ïA
+25°C
+60°C
+85°C
VDD = 5V(5)
Regulator Enabled
650
2000 ïA
+125°C
Legend:
Note 1:
2:
3:
4:
5:
Shading of rows is to assist in readability of the table.
The power-down current in Sleep mode does not depend on the oscillator type. Power-down current is measured with the
part in Sleep mode, with all I/O pins in a high-impedance state and tied to VDD or VSS, and all features that add delta
current are disabled (such as WDT, SOSC oscillator, BOR, etc.).
The supply current is mainly a function of operating voltage, frequency and mode. Other factors, such as I/O pin loading
and switching rate, oscillator type and circuit, internal code execution pattern and temperature, also have an impact on the
current consumption.
The test conditions for all IDD measurements in active operation mode are:
OSC1 = external square wave, from rail-to-rail; all I/O pins tri-stated, pulled to VDD;
MCLR = VDD; WDT enabled/disabled as specified.
Standard, low-cost 32 kHz crystals have an operating temperature range of -10°C to +70°C. Extended temperature
crystals are available at a much higher cost.
For LF devices, RETEN (CONFIG1L<0>) = 1.
For F devices, SRETEN (WDTCON<4>) = 1 and RETEN (CONFIG1L<0>) = 0.
DS39977F-page 548
ï£ 2010-2012 Microchip Technology Inc.
|
▷ |