PIC18F45K80-I Datasheet, PDF (291/622 Pages) Microchip Technology – 28/40/44/64-Pin, Enhanced Flash Microcontrollers with ECAN and nanoWatt XLP Technology

PIC18F66K80 FAMILY
21.3.4 ENABLING SPI I/O
To enable the serial port, MSSP Enable bit, SSPEN
(SSPCON1<5>), must be set. To reset or reconfigure
SPI mode, clear the SSPEN bit, reinitialize the
SSPCON registers and then set the SSPEN bit. This
configures the SDI, SDO, SCK and SS pins as serial
port pins. For the pins to behave as the serial port func-
tion, some must have their data direction bits (in the
TRIS register) appropriately programmed as follows:
• SDI is automatically controlled by the SPI module
• SDO must have the TRISC<5> bit cleared
• SCK (Master mode) must have the TRISC<3> bit
cleared
• SCK (Slave mode) must have the TRISC<3> bit
set
• SS must have the TRISA<5> bit set
Any serial port function that is not desired may be
overridden by programming the corresponding Data
Direction (TRIS) register to the opposite value.
21.3.5 TYPICAL CONNECTION
Figure 21-2 shows a typical connection between two
microcontrollers. The master controller (Processor 1)
initiates the data transfer by sending the SCK signal.
Data is shifted out of both shift registers on their pro-
grammed clock edge and latched on the opposite edge
of the clock. Both processors should be programmed to
the same Clock Polarity (CKP), then both controllers
would send and receive data at the same time.
Whether the data is meaningful (or dummy data)
depends on the application software. This leads to
three scenarios for data transmission:
• Master sends data–Slave sends dummy data
• Master sends data–Slave sends data
• Master sends dummy data–Slave sends data
FIGURE 21-2:
SPI MASTER/SLAVE CONNECTION
SPI Master SSPM<3:0> = 00xxb
SDO
Serial Input Buffer
(SSPBUF)
SPI Slave SSPM<3:0> = 010xb
SDI
Serial Input Buffer
(SSPBUF)
Shift Register
(SSPSR)
MSb
LSb
PROCESSOR 1
SDI
SCK
Serial Clock
SDO
Shift Register
(SSPSR)
MSb
LSb
SCK
PROCESSOR 2
 2010-2012 Microchip Technology Inc.
DS39977F-page 291