PIC18F45K80-I Datasheet, PDF (257/622 Pages) Microchip Technology – 28/40/44/64-Pin, Enhanced Flash Microcontrollers with ECAN and nanoWatt XLP Technology

PIC18F66K80 FAMILY
19.2 Capture Mode
In Capture mode, the CCPRxH:CCPRxL register pair
captures the 16-bit value of the Timer register selected
in the CCPTMRS when an event occurs on the CCPx
pin. An event is defined as one of the following:
• Every falling edge
• Every rising edge
• Every 4th rising edge
• Every 16th rising edge
Note:
For CCP2 only, the Capture mode can use
the CCP2 input pin as the capture trigger
for CCP2 or the input can function as a
time-stamp through the CAN module. The
CAN module provides the necessary
control and trigger signals.
The event is selected by the mode select bits,
CCPxM<3:0> (CCPxCON<3:0>). When a capture is
made, the interrupt request flag bit, CCPxIF (PIR4<x>),
is set; it must be cleared in software. If another capture
occurs before the value in CCPRx is read, the old
captured value is overwritten by the new captured
value.
Figure 19-1 shows the Capture mode block diagram.
19.2.1 CCP PIN CONFIGURATION
In Capture mode, the appropriate CCPx pin should be
configured as an input by setting the corresponding
TRIS direction bit.
19.2.2 TIMER1/3 MODE SELECTION
For the available timers (1/3) to be used for the capture
feature, the used timers must be running in Timer mode
or Synchronized Counter mode. In Asynchronous
Counter mode, the capture operation may not work.
The timer to be used with each CCP module is selected
in the CCPTMRS register. (See Section 19.1.1 “CCP
Modules and Timer Resources”.)
Details of the timer assignments for the CCP modules
are given in Table 19-2.
FIGURE 19-1:
CAPTURE MODE OPERATION BLOCK DIAGRAM
CCP3 Pin
Prescaler
 1, 4, 16
Set CCP3IF
C3TSEL
and
Edge Detect
C3TSEL
CCP3CON<3:0> ⁴
Q1:Q4 ⁴
CCP4CON<3:0> ⁴
Set CCP4IF
C4TSEL
CCP4 Pin
Prescaler
 1, 4, 16
and
Edge Detect
C4TSEL
TMR3H TMR3L
TMR3
Enable
CCPR3H
TMR1
Enable
CCPR3L
TMR1H TMR1L
TMR3H TMR3L
TMR3
Enable
CCPR4H CCPR4L
TMR1
Enable
TMR1H TMR1L
Note:
This block diagram uses CCP3 and CCP4, and their appropriate timers as an example. For details on all of
the CCP modules and their timer assignments, see Table 19-2.
 2010-2012 Microchip Technology Inc.
DS39977F-page 257