HD6473032F Datasheet, PDF (308/572 Pages) Hitachi Semiconductor – Hitachi Microcomputer

9.4 Usage Notes
9.4.1 Operation of TPC Output Pins
TP₀ to TP₁₅ are multiplexed with ITU pin functions. When ITU output is enabled, the
corresponding pins cannot be used for TPC output. The data transfer from NDR bits to DR bits
takes place, however, regardless of the usage of the pin.
Pin functions should be changed only under conditions in which the output trigger event will not
occur.
9.4.2 Note on Non-Overlapping Output
During non-overlapping operation, the transfer of NDR bit values to DR bits takes place as
follows.
1. NDR bits are always transferred to DR bits at compare match A.
2. At compare match B, NDR bits are transferred only if their value is 0. Bits are not transferred
if their value is 1.
Figure 9-9 illustrates the non-overlapping TPC output operation.
DDR
Q
NDER
Q
Compare match A
Compare match B
TPC output pin
C
Q DR D
Q NDR D
Internal
data bus
Figure 9-9 Non-Overlapping TPC Output
293