MC68HC908LB8_05 Datasheet, PDF (89/234 Pages) Freescale Semiconductor, Inc – M68HC08 Microcontrollers

9.7 I/O Registers
These registers control and monitor operation of the keyboard module:
• Keyboard status and control register (INTKBSCR)
• Keyboard interrupt enable register (INTKBIER)
I/O Registers
9.7.1 Keyboard Status and Control Register
The keyboard status and control register:
• Flags keyboard interrupt requests
• Acknowledges keyboard interrupt requests
• Masks keyboard interrupt requests
• Controls keyboard interrupt triggering sensitivity
Address: $001A
Bit 7
Read:
0
Write:
Reset:
0
6
5
0
0
0
0
= Unimplemented
4
3
2
1
Bit 0
0
KEYF
0
IMASKK MODEK
ACKK
0
0
0
0
0
Figure 9-4. Keyboard Status and Control Register (INTKBSCR)
Bits 7–4 — Not used
These read-only bits always read as 0s.
KEYF — Keyboard Flag Bit
This read-only bit is set when a keyboard interrupt is pending. Reset clears the KEYF bit.
1 = Keyboard interrupt pending
0 = No keyboard interrupt pending
ACKK — Keyboard Acknowledge Bit
Writing a 1 to this write-only bit clears the keyboard interrupt request. ACKK always reads as 0. Reset
clears ACKK.
IMASKK — Keyboard Interrupt Mask Bit
Writing a 1 to this read/write bit prevents the output of the keyboard interrupt mask from generating
interrupt requests. Reset clears the IMASKK bit.
1 = Keyboard interrupt requests masked
0 = Keyboard interrupt requests not masked
MODEK — Keyboard Triggering Sensitivity Bit
This read/write bit controls the triggering sensitivity of the keyboard interrupt pins. Reset clears
MODEK.
1 = Keyboard interrupt requests on falling edges and low levels
0 = Keyboard interrupt requests on falling edges only
9.7.2 Keyboard Interrupt Enable Register
The keyboard interrupt enable register enables or disables each port A pin to operate as a keyboard
interrupt pin.
MC68HC908LB8 Data Sheet, Rev. 1
Freescale Semiconductor
89