MC68HC908LB8_05 Datasheet, PDF (221/234 Pages) Freescale Semiconductor, Inc – M68HC08 Microcontrollers

Chapter 20
Electrical Specifications
20.1 Introduction
This section contains electrical and timing specifications.
20.2 Absolute Maximum Ratings
Maximum ratings are the extreme limits to which the MCU can be exposed without permanently damaging
it.
NOTE
This device is not guaranteed to operate properly at the maximum ratings.
Refer to 20.5 5.0-Volt Electrical Characteristics and for guaranteed
operating conditions.
Characteristic⁽¹⁾
Supply voltage
Input voltage
Maximum current per pin
excluding those specified below
Maximum current into V_DD
Maximum current out of V_SS
Storage temperature
NOTES:
1. Voltages referenced to V_SS
Symbol
V_DD
V_In
I
I_MVDD
I_MVSS
T_stg
Value
–0.3 to + 6.0
V_SS – 0.3 to V_DD + 0.3
± 15
100
100
–55 to +150
Unit
V
V
mA
mA
mA
°C
NOTE
This device contains circuitry to protect the inputs against damage due to
high static voltages or electric fields; however, it is advised that normal
precautions be taken to avoid application of any voltage higher than
maximum-rated voltages to this high-impedance circuit. For proper
operation, it is recommended that V_In and V_Out be constrained to the range
V_SS ≤ (V_In or V_Out) ≤ V_DD. Reliability of operation is enhanced if unused
inputs are connected to an appropriate logic voltage level (for example,
either V_SS or V_DD).
MC68HC908LB8 Data Sheet, Rev. 1
Freescale Semiconductor
221