MC68HC05V12 Datasheet, PDF (156/246 Pages) Freescale Semiconductor, Inc – HCMOS Microcontreller Unit

Freescale Semiconductor, Inc.
Byte Data Link Controller – Digital
During arbitration, or even throughout the transmitting message, when
an opposite bit is detected, transmission is stopped immediately unless
it occurs on the 8th bit of a byte. In this case, the BDLC automatically will
append up to two extra logic 1 bits and then stop transmitting. These two
extra bits will be arbitrated normally and thus will not interfere with
another message. The second logic 1 bit will not be sent if the first loses
arbitration. If the BDLC has lost arbitration to another valid message,
then the two extra logic 1s will not corrupt the current message.
However, if the BDLC has lost arbitration due to noise on the bus, then
the two extra logic 1s will ensure that the current message will be
detected and ignored as a noise-corrupted message.
14.6 BDLC Protocol Handler
The protocol handler is responsible for framing, arbitration, CRC
generation/checking, and error detection. The protocol handler
conforms to SAE J1850 Class B Data Communications Network
Interface.
NOTE: Freescale assumes that the reader is familiar with the J1850 specification
before reading this protocol handler description.
TO CPU
CPU INTERFACE
PROTOCOL HANDLER
MUX INTERFACE
PHYSICAL INTERFACE
BDLC
TO J1850 BUS
Figure 14-13. BDLC Block Diagram
Technical Data
Byte Data Link Controller – Digital (BDLC–D)
For More Information On This Product,
Go to: www.freescale.com
MC68HC05V12 — Rev. 2.0