Z51F0410 Datasheet, PDF (167/184 Pages) Zilog, Inc. – Z8051 Series 8-Bit Microcontrollers

Z51F0410
Product Specification
(3) Write 0xA5 to 0xF555.
1 _{Refer to how to enter ISP mode..}
2 _{Command sequence to activate Flash write/erase mode. It is composed of sequentially writing data}
of Flash memory.
8.4.1.3 Flash write mode
Step 1. Enable program mode.
Step 2. Reset page buffer. FEMR: 1000_0001 FECR:0000_0010
Step 3. Select page buffer. FEMR:1000_1001
Step 4. Write data to page buffer.(Address automatically increases by twin.)
Step 5. Set write mode. FEMR:1010_0001
Step 6. Set page address. FEARH:FEARM:FEARL=20’hx_xxxx
Step 7. Set FETCR.
Step 8. Start program. FECR:0000_1011
Step 9. Insert one NOP operation
Step 10. Read FESR until PEVBSY is 1.
Step 11. Repeat step2 to step 8 until all pages are written.
8.4.1.4 Flash page erase mode
Step 1. Enable program mode.
Step 2. Reset page buffer. FEMR: 1000_0001 FECR:0000_0010
Step 3. Select page buffer. FEMR:1000_1001
Step 4. Write ‘h00 to page buffer. (Data value is not important.)
Step 5. Set erase mode. FEMR:1001_0001
Step 6. Set page address. FEARH:FEARM:FEARL=20’hx_xxxx
Step 7. Set FETCR.
Step 8. Start erase. FECR:0000_1011
Step 9. Insert one NOP operation
Step 10. Read FESR until PEVBSY is 1.
Step 11. Repeat step2 to step 8 until all pages are erased.
8.4.1.5 Flash bulk erase mode
Step 1. Enable program mode.
Step 2. Reset page buffer. FEMR: 1000_0001 FECR:0000_0010
Step 3. Select page buffer. FEMR:1000_1001
Step 4. Write ‘h00 to page buffer. (Data value is not important.)
Step 5. Set erase mode. FEMR:1001_0001.
(Only main cell area is erased. For bulk erase including OTP area, select OTP area.(set FEMR
to 1000_1101.)
Step 6. Set FETCR
Step 7. Start bulk erase. FECR:1000_1011
PS029502-0212
PRELIMINARY
164