SMJ320F240 Datasheet, PDF (58/99 Pages) Texas Instruments – DSP CONTROLLER

SMJ320F240
DSP CONTROLLER
SGUS029 – APRIL 1999
output current variation with output voltage: SPICE simulation results (4.5 V, 150° C)
Table 15. Typical Output Source Current vs. Output Voltage High
2.4 V
3.0 V
3.5 V
4.0 V
RS
See complete listing of pin names†
–19 mA
–16 mA
–16 mA
–13.5 mA
–12 mA
–9.5 mA
–6 mA
–5.0 mA
All other inputs
–23 mA
–18.5 mA
–13 mA
–6.5 mA
† _{IOPA[0:3], SCIRXD/IO, SCITXD/IO, XINT2/IO, XINT3/IO, ADCSOC/IOPC0, TMRDIR/IOPB6, TMRCLK/IOPB7 EMU0, EMU1/OFF}
Table 16. Typical Output Sink Current vs. Output Voltage Low
0.6 V
0.4 V
0.2 V
RS
See complete listing of pin names†
8 mA
7.5 mA
6 mA
5 mA
3 mA
2.5 mA
All other inputs
14.5 mA
10 mA
5.0 mA
† _{IOPA[0:3], SCIRXD/IO, SCITXD/IO, XINT2/IO, XINT3/IO, ADCSOC/IOPC0, TMRDIR/IOPB6, TMRCLK/IOPB7 EMU0, EMU1/OFF}
electrical characteristics over recommended ranges of supply voltage and operating free-air
temperature (unless otherwise noted)
VOH
VOL
PARAMETER
High-level output voltage
Low-level output voltage
II
Input current
IOZ
Output current, high-impedance state
(off-state)
Supply current, operating mode
Supply current, Idle 1 low-power mode
IDD Supply current, Idle 2 low-power mode
Supply current, PLL power-down mode
Supply current, OSC power-down mode
Ci
Input capacitance
Co Output capacitance
IDDP Flash programming supply current
TEST CONDITIONS
IOH = MAX
IOL = MAX
TRST with internal pulldown
EMU0, EMU1/OFF, TMS, TCK,
and TDI, with internal pullup
All other input pins
VI = VSS or VDD
MIN
2.4
–10
– 500
–10
VO = VDD or 0 V
–5
tc(CO) = 50 ns
tc(CO) = 50 ns
tc(CO) = 50 ns
tc(CO) = 50 ns
tc(CO) = 50 ns
tc(CO) = 50 ns
TYP MAX UNIT
V
0.6 V
500
10 µA
10
5 µA
80
50
mA
7
1
400
µA
15
pF
15
pF
10
mA
58
• POST OFFICE BOX 1443 HOUSTON, TEXAS 77251–1443