HD64F3337YCP16V Datasheet, PDF (103/749 Pages) Renesas Technology Corp – Old Company Name in Catalogs and Other Documents

Section 4 Exception Handling
4.1 Overview
The H8/3337 Series and H8/3397 Series recognize two kinds of exceptions: interrupts and the
reset. Table 4.1 indicates their priority and the timing of their hardware exception-handling
sequence.
Table 4.1 Hardware Exception-Handling Sequences and Priority
Type of
Detection
Priority Exception Timing
Timing of Exception-Handling Sequence
High
Reset
Synchronized
with clock
The hardware exception-handling sequence begins
as soon as RES changes from low to high.
Interrupt
End of instruction When an interrupt is requested, the hardware
execution*
exception-handling sequence begins at the end of
the current instruction, or at the end of the current
Low
hardware exception-handling sequence.
Note: * Not detected after ANDC, ORC, XORC, and LDC instructions.
4.2 Reset
4.2.1 Overview
A reset has the highest exception-handling priority. When the RES pin goes low or when there is a
watchdog timer reset (when the reset option is selected for watchdog timer overflow), all current
processing stops and the chip enters the reset state. The internal state of the CPU and the registers
of the on-chip supporting modules are initialized. The reset exception-handling sequence starts
when RES returns from low to high, or at the end of a watchdog reset pulse.
4.2.2 Reset Sequence
The reset state begins when RES goes low or a watchdog reset is generated. To ensure correct
resetting, at power-on the RES pin should be held low for at least 20 ms. In a reset during
operation, the RES pin should be held low for at least 10 system clock cycles. The watchdog reset
pulse width is always 518 system clocks. For the pin states during a reset, see appendix D, Port
States in Each Mode.
71