|
SAM7X128_14 Datasheet, PDF (654/662 Pages) ATMEL Corporation – ARM-based Flash MCU | |||
|
◁ |
Version
6120F
(Continued) Comments
Change
Request
Ref.
Section 34. âUSB Device Port (UDP)â on page 441: Corrections, improvements, additions and deletions
throughout section, new source document.
Section 34.5.3.8 âSending a Device Remote Wakeupâ replaces title âSending an External Resume.
WAKEUP bit shown in interruput registers: Section 34.6.4 on page 450 thru Section 34.6.8 on page 455
3288
RMWUPE, RSMINPR, ESR bits removed from Section 34.6.2 âUDP Global State Registerâ
NOTE: pertinent to USB pullup effect on USB Reset added to Section 34.6.12 âUDP Transceiver Control
Registerâ.
ADC: Section 35.2 âBlock Diagramâ on page 463 dedicated and I/O line multiplexed inputs differentiated.
âADC Timingsâ on page 486 typo corrected in warning
3052
2830
CAN: Update to message acceptance example in Section 36.6.2.1 âMessage Acceptance Procedureâ on 2295, 2296
page 484.
New information on byte priority added to Section 36.8.17 âCAN Message Data Low Registerâ on page 531 2476
and Section 36.8.18 âCAN Message Data High Registerâ on page 532.
Corrected MDL bit description in Section 36.8.17 âCAN Message Data Low Registerâ on page 531.
Update to specify allowed values for BRP field on Section 36.6.4 âCAN 2.0 Standard Featuresâ, page 489 2597
and in Section 36.8.6 âCAN Baudrate Registerâ on page 518.
EMAC: âInterrupt Enable Registerâ on page 559, access changed to Write-only.
âInterrupt Disable Registerâ on page 560, access changed to Write-only.
âInterrupt Mask Registerâ on page 561, access changed to Read-only.
1725
Section 38. âSAM7X512/256/128 Electrical Characteristicsâ
âAbsolute Maximum Ratingsâ on page 581 change to Maximum Operating Voltages
3059
Changed conditions of parameters IPULLUP and ILEAK in Table 38-2, âDC Characteristics,â on page 582.
Updated Table 38-5, âDC Flash Characteristics SAM7X512/256/128,â on page 583 and Table 38-9, âMain
Oscillator Characteristics,â on page 587.
Added Table 38-10, âCrystal Characteristics,â on page 588.
Updated IDDBP in Table 38-11, âXIN Clock Electrical Characteristics,â on page 588.
Added information on data sampling in SPI master mode to Table 38-21, âSPI Timings,â on page 595.
Updated Table 38-22, âEMAC Signals,â on page 596
Added Table 38-24, âEMAC RMII Specific Signals (Only for SAM7X512),â on page 598 and Figure 38-9,
âEMAC RMII Modeâ on page 598.
rfo review
Errata updated:
Added Section 41.1 âMarkingâ on page 607.
Section 41.3.6.1 âRTT: Possible Event Loss when Reading RTT_SRâ
Section 41.3.7.4 âSPI: Chip Select and Fixed Modeâ
Section 41.3.7.5 âSPI: Baudrate Set to 1â
TWI: Behavior of OVRE Bit (removed)
Section 41.3.9.5 âTWI: Software Resetâ
Section 41.3.10.2 âUSART: Hardware Handshaking â Two Characters Sentâ
Section 41.3.10.3 âUSART: RXBRK Flag Error in Asynchronous Modeâ
#2871
PIO: Leakage on PB27 - PB 30 ....âthe leakage can be 25 µA in worst case...â
rfo review
SAM7X Series [DATASHEET]
6120KâATARMâ11-Feb-14
654
|
▷ |