SAM7X128_14 Datasheet, PDF (380/662 Pages) ATMEL Corporation – ARM-based Flash MCU

 Software Trigger: Each channel has a software trigger, available by setting SWTRG in TC_CCR.
 SYNC: Each channel has a synchronization signal SYNC. When asserted, this signal has the same effect as a
software trigger. The SYNC signals of all channels are asserted simultaneously by writing TC_BCR (Block Control)
with SYNC set.
 Compare RC Trigger: RC is implemented in each channel and can provide a trigger when the counter value matches
the RC value if CPCTRG is set in TC_CMR.
The channel can also be configured to have an external trigger. In Capture Mode, the external trigger signal can be
selected between TIOA and TIOB. In Waveform Mode, an external event can be programmed on one of the following
signals: TIOB, XC0, XC1 or XC2. This external event can then be programmed to perform a trigger by setting ENETRG
in TC_CMR.
If an external trigger is used, the duration of the pulses must be longer than the master clock period in order to be
detected.
Regardless of the trigger used, it will be taken into account at the following active edge of the selected clock. This means
that the counter value can be read differently from zero just after a trigger, especially when a low frequency signal is
selected as the clock.
32.5.7 Capture Operating Mode
This mode is entered by clearing the WAVE parameter in TC_CMR (Channel Mode Register).
Capture Mode allows the TC channel to perform measurements such as pulse timing, frequency, period, duty cycle and
phase on TIOA and TIOB signals which are considered as inputs.
Figure 32-5 shows the configuration of the TC channel when programmed in Capture Mode.
32.5.8 Capture Registers A and B
Registers A and B (RA and RB) are used as capture registers. This means that they can be loaded with the counter value
when a programmable event occurs on the signal TIOA.
The LDRA parameter in TC_CMR defines the TIOA edge for the loading of register A, and the LDRB parameter defines
the TIOA edge for the loading of Register B.
RA is loaded only if it has not been loaded since the last trigger or if RB has been loaded since the last loading of RA.
RB is loaded only if RA has been loaded since the last trigger or the last loading of RB.
Loading RA or RB before the read of the last value loaded sets the Overrun Error Flag (LOVRS) in TC_SR (Status
Register). In this case, the old value is overwritten.
32.5.9 Trigger Conditions
In addition to the SYNC signal, the software trigger and the RC compare trigger, an external trigger can be defined.
The ABETRG bit in TC_CMR selects TIOA or TIOB input signal as an external trigger. The ETRGEDG parameter defines
the edge (rising, falling or both) detected to generate an external trigger. If ETRGEDG = 0 (none), the external trigger is
disabled.
SAM7X Series [DATASHEET]
6120K–ATARM–11-Feb-14
380