SAM7X128_14 Datasheet, PDF (463/662 Pages) ATMEL Corporation – ARM-based Flash MCU

35. Analog-to-Digital Converter (ADC)
35.1 Overview
The ADC is based on a Successive Approximation Register (SAR) 10-bit Analog-to-Digital Converter (ADC). It also
integrates an 8-to-1 analog multiplexer, making possible the analog-to-digital conversions of 8 analog lines. The
conversions extend from 0V to ADVREF.
The ADC supports an 8-bit or 10-bit resolution mode, and conversion results are reported in a common register for all
channels, as well as in a channel-dedicated register. Software trigger, external trigger on rising edge of the ADTRG pin
or internal triggers from Timer Counter output(s) are configurable.
The ADC also integrates a Sleep Mode and a conversion sequencer and connects with a PDC channel. These features
reduce both power consumption and processor intervention.
Finally, the user can configure ADC timings, such as Startup Time and Sample & Hold Time.
35.2 Block Diagram
Figure 35-1. Analog-to-Digital Converter Block Diagram
Timer
Counter
Channels
ADC Controller
PMC
MCK
ADTRG
VDDIN
ADVREF
AD-
Dedicated
Analog
AD-
Inputs
AD-
AD-
Analog Inputs
PIO
Multiplexed
AD-
with I/O lines
AD-
Trigger
Selection
ADC cell
Successive
Approximation
Register
Analog-to-Digital
Converter
Control
Logic
ADC Interrupt
AIC
User
Interface
PDC
ASB
Peripheral Bridge
APB
GND
SAM7X Series [DATASHEET]
6120K–ATARM–11-Feb-14
463