LM3S8G62 Datasheet, PDF (983/1096 Pages) Texas Instruments – Stellaris® LM3S8G62 Microcontroller

OBSOLETE: TI has discontinued production of this device.
Stellaris^® LM3S8G62 Microcontroller
Table 22-2. Signals by Pin Number (continued)
Pin Number
Pin Name
Pin Type Buffer Type^a Description
PB5
I/O
TTL
GPIO port B bit 5.
AIN11
I
Analog Analog-to-digital converter input 11.
C0o
O
TTL
Analog comparator 0 output.
C1-
I
Analog Analog comparator 1 negative input.
CAN0Tx
O
TTL
CAN module 0 transmit.
91
CCP0
I/O
TTL
Capture/Compare/PWM 0.
CCP2
I/O
TTL
Capture/Compare/PWM 2.
CCP5
I/O
TTL
Capture/Compare/PWM 5.
CCP6
I/O
TTL
Capture/Compare/PWM 6.
U1Tx
O
TTL
UART module 1 transmit. When in IrDA mode, this signal has IrDA
modulation.
PB4
I/O
TTL
GPIO port B bit 4.
AIN10
I
Analog Analog-to-digital converter input 10.
C0-
92
CAN0Rx
I
Analog Analog comparator 0 negative input.
I
TTL
CAN module 0 receive.
IDX0
I
TTL
QEI module 0 index.
U1Rx
I
TTL
UART module 1 receive. When in IrDA mode, this signal has IrDA
modulation.
93
VDD
-
Power Positive supply for I/O and some logic.
94
GND
-
Power Ground reference for logic and I/O pins.
PD4
I/O
TTL
GPIO port D bit 4.
AIN7
I
Analog Analog-to-digital converter input 7.
95
CCP0
I/O
TTL
Capture/Compare/PWM 0.
CCP3
I/O
TTL
Capture/Compare/PWM 3.
PD5
I/O
TTL
GPIO port D bit 5.
AIN6
I
Analog Analog-to-digital converter input 6.
96
CCP2
I/O
TTL
Capture/Compare/PWM 2.
CCP4
I/O
TTL
Capture/Compare/PWM 4.
GNDA
97
-
Power The ground reference for the analog circuits (ADC, Analog
Comparators, etc.). These are separated from GND to minimize
the electrical noise contained on VDD from affecting the analog
functions.
VDDA
98
-
Power The positive supply for the analog circuits (ADC, Analog
Comparators, etc.). These are separated from VDD to minimize
the electrical noise contained on VDD from affecting the analog
functions. VDDA pins must be supplied with a voltage that meets
the specification in Table 24-2 on page 1031 , regardless of system
implementation.
PD6
I/O
TTL
GPIO port D bit 6.
99
AIN5
I
Analog Analog-to-digital converter input 5.
Fault0
I
TTL
PWM Fault 0.
July 24, 2012
983
Texas Instruments-Production Data