LM3S8G62 Datasheet, PDF (542/1096 Pages) Texas Instruments – Stellaris® LM3S8G62 Microcontroller

OBSOLETE: TI has discontinued production of this device.
Analog-to-Digital Converter (ADC)
number of samples in the averaging calculation. For example, if the averaging circuit is configured
to average 16 samples, the throughput is decreased by a factor of 16.
By default the averaging circuit is off, and all data from the converter passes through to the sequencer
FIFO. The averaging hardware is controlled by the ADC Sample Averaging Control (ADCSAC)
register (see page 579). A single averaging circuit has been implemented, thus all input channels
receive the same amount of averaging whether they are single-ended or differential.
Figure 12-6 shows an example in which the ADCSAC register is set to 0x2 for 4x hardware
oversampling and the IE1 bit is set for the sample sequence, resulting in an interrupt after the
second averaged value is stored in the FIFO.
Figure 12-6. Sample Averaging Example
A+B+C+D
4
A+B+C+D
4
INT
12.3.4
Analog-to-Digital Converter
The Analog-to-Digital Converter (ADC) module uses a Successive Approximation Register (SAR)
architecture to deliver a 12-bit, low-power, high-precision conversion value. The ADC defaults to a
10-bit conversion result, providing backwards compatibility with previous generations of Stellaris
microcontrollers. To enable 12-bit resolution, set the RES bit in the ADC Control (ADCCTL) register.
The successive-approximation algorithm uses a current mode D/A converter to achieve lower settling
time, resulting in higher conversion speeds for the A/D converter. In addition, built-in sample-and-hold
circuitry with offset-calibration circuitry improves conversion accuracy. The ADC must be run from
the PLL or a 16-MHz clock source. Figure 12-7 shows the ADC input equivalency diagram; for
parameter values, see “Analog-to-Digital Converter (ADC)” on page 1042.
542
July 24, 2012
Texas Instruments-Production Data