LM3S8G62 Datasheet, PDF (1009/1096 Pages) Texas Instruments – Stellaris® LM3S8G62 Microcontroller

OBSOLETE: TI has discontinued production of this device.
Stellaris^® LM3S8G62 Microcontroller
Table 22-7. Signals by Pin Number (continued)
Pin Number
Pin Name
Pin Type Buffer Type^a Description
PC5
I/O
TTL
GPIO port C bit 5.
C0o
O
TTL
Analog comparator 0 output.
C1+
I
Analog Analog comparator 1 positive input.
M1
C1o
O
TTL
Analog comparator 1 output.
CCP1
I/O
TTL
Capture/Compare/PWM 1.
CCP3
I/O
TTL
Capture/Compare/PWM 3.
Fault2
I
TTL
PWM Fault 2.
PC6
I/O
TTL
GPIO port C bit 6.
CCP0
I/O
TTL
Capture/Compare/PWM 0.
M2
CCP3
I/O
TTL
Capture/Compare/PWM 3.
PhB0
I
TTL
QEI module 0 phase B.
U1Rx
I
TTL
UART module 1 receive. When in IrDA mode, this signal has IrDA
modulation.
PA1
I/O
TTL
GPIO port A bit 1.
U0Tx
M3
O
TTL
UART module 0 transmit. When in IrDA mode, this signal has IrDA
modulation.
U1Tx
O
TTL
UART module 1 transmit. When in IrDA mode, this signal has IrDA
modulation.
PA2
I/O
TTL
GPIO port A bit 2.
M4
PWM4
O
TTL
PWM 4. This signal is controlled by PWM Generator 2.
SSI0Clk
I/O
TTL
SSI module 0 clock
PA5
I/O
TTL
GPIO port A bit 5.
M5
CAN0Tx
O
TTL
CAN module 0 transmit.
SSI0Tx
O
TTL
SSI module 0 transmit
PA7
I/O
TTL
GPIO port A bit 7.
CAN0Tx
O
TTL
CAN module 0 transmit.
CCP3
I/O
TTL
Capture/Compare/PWM 3.
M6
CCP4
I/O
TTL
Capture/Compare/PWM 4.
PWM1
O
TTL
PWM 1. This signal is controlled by PWM Generator 0.
PWM5
O
TTL
PWM 5. This signal is controlled by PWM Generator 2.
M7
RXIP
I
Analog RXIP of the Ethernet PHY.
M8
TXOP
O
TTL
TXOP of the Ethernet PHY.
PF0
I/O
TTL
GPIO port F bit 0.
PWM0
M9
PhB0
O
TTL
PWM 0. This signal is controlled by PWM Generator 0.
I
TTL
QEI module 0 phase B.
U1DSR
I
TTL
UART module 1 Data Set Ready modem output control line.
M10
WAKE
I
TTL
An external input that brings the processor out of Hibernate mode
when asserted.
M11
OSC1
O
Analog Main oscillator crystal output. Leave unconnected when using a
single-ended clock source.
M12
HIB
O
OD
An output that indicates the processor is in Hibernate mode.
a. The TTL designation indicates the pin has TTL-compatible voltage levels.
July 24, 2012
Texas Instruments-Production Data
1009