LAN9420 Datasheet, PDF (74/171 Pages) SMSC Corporation – Single-Chip Ethernet Controller with HP Auto-MDIX Support and PCI Interface

Single-Chip Ethernet Controller with HP Auto-MDIX Support and PCI Interface
Datasheet
3.6.8.2
3.6.9
3.6.9.1
3.6.9.2
3.6.10
3.6.11
Energy Detect Power-Down
This power-down mode is activated by setting the PHY register bit 17.13 to 1. Please refer to Section
4.5.8, "Mode Control/Status," on page 144 for additional information on this register. In this mode when
no energy is present on the line, the PHY is powered down, with the exception of the management
interface, the SQUELCH circuit and the ENERGYON logic. The ENERGYON logic is used to detect
the presence of valid energy from 100BASE-TX, 10BASE-T, or Auto-negotiation signals
In this mode, when the ENERGYON signal is low, the PHY is powered-down, and nothing is
transmitted. When energy is received - link pulses or packets - the internal ENERGYON signal is
asserted, and the PHY powers-up. It automatically resets itself into the state it had prior to power-down,
and asserts the INT7 bit of the PHY Interrupt Source Flag register. If the ENERGYON interrupt is
enabled, this event will cause a PHY interrupt to the Interrupt Controller and the power management
event detection logic.
The first and possibly the second packet to activate ENERGYON may be lost.
When 17.13 is low, energy detect power-down is disabled.
PHY Resets
In addition to a chip-level reset, the PHY supports two software-initiated resets. These are discussed
in the following sections.
PHY Soft Reset via PMT_CTRL bit 10 (PHY_RST)
The PHY soft reset is initiated by writing a ‘1’ to bit 10 of the PMT_CTRL register (PHY_RST). This
self-clearing bit will return to ‘0’ after approximately 100μs, at which time the PHY reset is complete.
PHY Soft Reset via PHY Basic Control Register bit 15 (PHY Reg. 0.15)
The PHY Reg. 0.15 Soft Reset is initiated by writing a ‘1’ to bit 15 of the PHY’s Basic Control Register.
This self-clearing bit will return to ‘0’ after approximately 256μs, at which time the PHY reset is
complete. The BCR reset initializes the logic within the PHY, with the exception of register bits marked
as NASR (Not Affected by Software Reset).
Required Ethernet Magnetics
The magnetics selected for use with LAN9420/LAN9420i should be an Auto-MDIX style magnetic
available from several vendors. The user is urged to review SMSC Application Note 8.13 "Suggested
Magnetics" for the latest qualified and suggested magnetics. Vendors and part numbers are provided
in this application note.
PHY Registers
Please refer to Section 4.5, "PHY Registers," on page 136 for a complete description of the PHY
registers.
3.7 Power Management
3.7.1
Overview
LAN9420/LAN9420i supports the mandatory D0, D3_HOT and D3_COLD power states.
LAN9420/LAN9420i can signal a wake event detection by asserting the nPME pin. The nPME signal
can be generated in all states, including (optionally) the D3_COLD state. LAN9420/LAN9420i can assert
the nPME signal upon detection of various power management events, such as an Ethernet “Wake On
LAN”, or upon detection of an Ethernet link status change.
Revision 1.6 (07-18-11)
74
DATASHEET
SMSC LAN9420/LAN9420i