LAN9420 Datasheet, PDF (47/171 Pages) SMSC Corporation – Single-Chip Ethernet Controller with HP Auto-MDIX Support and PCI Interface

Single-Chip Ethernet Controller with HP Auto-MDIX Support and PCI Interface
Datasheet
BITS
8
7
6:3
2
1
Table 3.9 TDES0 Bit Fields (continued)
DESCRIPTION
EC - Excessive Collision
When set, indicates that the transmission was aborted after 16 successive collisions while
attempting to transmit the current frame.
Host Actions: Checks this bit to determine status.
DMAC Actions: Sets/clears this bit to define status.
RESERVED
Host Actions: Cleared on writes and ignored on reads.
DMAC Actions: Ignored on reads and cleared on writes.
CC - Collision Count
This 4-bit counter indicates the number of collisions that occurred before the frame was transmitted.
Not valid when the excessive collisions bit (EC - TDES0[8]) is also set.
Host Actions: Reads this field to determine Collision Count.
DMAC Actions: Initializes this field to define Collision Count.
ED - Excessive Deferral
If the deferred bit is set in the control register, the setting of the Excessive Deferral bit indicates
that the transmission has ended because of deferral of over 24,288-bit times during transmission.
Host Actions: Checks this bit to determine status.
DMAC Actions: Sets/clears this bit to define status.
Reserved
0
DE - Deferred
When set, indicates that the DMA Controller had to defer while ready to transmit a frame because
the carrier was asserted.
Host Actions: Checks this bit to determine status.
DMAC Actions: Sets/clears this bit to define status.
Transmit Descriptor 1 (TDES1)
BITS
31
30
Table 3.10 TDES1 Bit Fields
DESCRIPTION
IC - Interrupt on Completion
When set, the DMA Controller sets transmit interrupt (TI - DMAC_STATUS[0]) after the present
frame has been transmitted. This field is valid only when last segment (LS - TDES1[30]) is set.
Host Actions: Initializes this bit.
DMAC Actions: Reads this bit to determine whether IOC should be asserted.
LS - Last Segment
When set, indicates that the buffer contains the last segment of a frame.
Host Actions: Initializes this bit.
DMAC Actions: Reads this bit to determine whether the buffer contains the last segment of a
frame.
SMSC LAN9420/LAN9420i
47
DATASHEET
Revision 1.6 (07-18-11)