LAN9420 Datasheet, PDF (123/171 Pages) SMSC Corporation – Single-Chip Ethernet Controller with HP Auto-MDIX Support and PCI Interface

Single-Chip Ethernet Controller with HP Auto-MDIX Support and PCI Interface
Datasheet
BITS
2
1-0
DESCRIPTION
Receiver Enable (RXEN)
When set (1), the MAC’s receiver is enabled and will receive frames from
the internal PHY. When reset, the MAC’s receiver is disabled and will not
receive any frames from the internal PHY.
Note:
In order to successfully enable the receive path, the RX DMAC
must be enabled by setting the Start/Stop Receive bit (SR) bit of
the DMA Controller Control (Operation Mode) Register
(DMAC_CONTROL) prior to enabling the receiver (by setting
RXEN).
Note:
In order to successfully disable the receive path, the receiver must
be disabled (by clearing RXEN) prior to disabling the RX DMAC
(by clearing the Start/Stop Receive bit (SR) bit of the DMA
Controller Control (Operation Mode) Register
(DMAC_CONTROL)). Otherwise, RX DMA will not stop
(DMAC_STATUS will continue to show the Receive Process State
(RS) as Running and Receive Process Stopped (RPS) does not
assert).
RESERVED
TYPE
R/W
RO
DEFAULT
0b
-
SMSC LAN9420/LAN9420i
123
DATASHEET
Revision 1.6 (07-18-11)