LAN9420 Datasheet, PDF (44/171 Pages) SMSC Corporation – Single-Chip Ethernet Controller with HP Auto-MDIX Support and PCI Interface

Single-Chip Ethernet Controller with HP Auto-MDIX Support and PCI Interface
Datasheet
Receive Descriptor 1 (RDES1)
BITS
31:26
25
24
23:22
21:11
10:0
Table 3.6 RDES1 Bit Fields
DESCRIPTION
RESERVED
Host Actions: Cleared on writes and ignored on reads.
DMAC Actions: Ignored on reads. DMAC does not write to RDES1.
RER - Receive End of Ring
When set, indicates that the DMAC reached the final descriptor. Upon servicing this descriptor,
the DMAC returns to the base address of the DMA descriptor list pointed to by the Receive List
Base Address Register (RX_BASE_ADDR).
Host Actions: Initializes this bit.
DMAC Actions: Reads this bit to determine if this is the final descriptor in the ring.
RCH - Second Address Chained
When set, indicates that the second address in the descriptor is the next descriptor address,
rather than the second buffer address. When RCH is set, RBS2 (RDES1[21:11]) must be all
zeros. RCH is ignored if RER (RDES1[25]) is set.
Host Actions: Initializes this bit.
DMAC Actions: Reads this bit to determine if second address is next descriptor address.
RESERVED
Host Actions: Cleared on writes and ignored on reads.
DMAC Actions: Ignored on reads. DMAC does not write to RDES1.
RBS2 - Receive Buffer 2 Size
Indicates the size, in bytes, of the second data buffer. The buffer size must be a multiple of 4.
This field is not valid if RCH (RDES1[24]) is set.
Host Actions: Initializes this field.
DMAC Actions: Reads this field to determine the allocated size of associated data buffer.
RBS1 - Receive Buffer 1 Size
Indicates the size, in bytes, of the first data buffer. The buffer size must be a multiple of 4. In the
case the buffer size is not a multiple of 4, the resulting behavior is undefined. If this field is 0,
the DMA controller ignores this buffer and uses buffer2. (This field cannot be zero if the
descriptor chaining is used – Second Address Chained (RCH - RDES1[24]) is set).
Host Actions: Initializes this field.
DMAC Actions: Reads this field to determine the allocated size of associated data buffer.
Receive Descriptor 2 (RDES2)
BITS
31:0
Table 3.7 RDES2 Bit Fields
DESCRIPTION
Buffer 1 Address Pointer
Indicates the address of buffer 1 in the Host memory. There are no limitations on the buffer
address alignment.
Host Actions: Initializes this field.
DMAC Actions: Reads this field upon opening a new DMA descriptor to obtain the buffer
address.
Revision 1.6 (07-18-11)
44
DATASHEET
SMSC LAN9420/LAN9420i