PIC24FJ256DA210 Datasheet, PDF (73/408 Pages) Microchip Technology – 64/100-Pin, 16-Bit Flash Microcontrollers with Graphics Controller and USB On-The-Go (OTG)

PIC24FJ256DA210 FAMILY
4.2.5.2 Data Write into EDS Space
In order to write data to EDS space, such as in EDS
reads, an Address Pointer is set up by loading the
required EDS page number into the DSWPAG register,
and assigning the offset address to one of the W regis-
ters. Once the above assignment is done, then the
EDS window is enabled by setting bit 15 of the working
register, assigned with the offset address, and the
accessed location can be written.
Figure 4-2 illustrates how the EDS space address is
generated for write operations.
FIGURE 4-6:
EDS ADDRESS GENERATION FOR WRITE OPERATIONS
Select
1
8
0
DSWPAG Reg
9 Bits
24-Bit EA
Wn
15 Bits
Wn<0> is Byte Select
When the MSBs of EA is ‘1’, the lower 9 bits of
DSWPAG are concatenated to the lower 15 bits of EA
to form a 24-bit EDS address for write operations.
Example 4-2 shows how to write a byte, word and dou-
ble-word to EDS.
EXAMPLE 4-2: EDS WRITE CODE IN ASSEMBLY
; Set the EDS page where the data to be written
mov
#0x0002 , w0
mov
w0 , DSWPAG ;page 2 is selected for write
mov
#0x0800 , w1 ;select the location (0x800) to be written
bset w1 , #15
;set the MSB of the base address, enable EDS mode
;Write a byte to the selected location
mov
#0x00A5 , w2
mov
#0x003C , w3
mov.b w2 , [w1++]
;write Low byte
mov.b w3 , [w1++] ;write High byte
;Write a word to the selected location
mov
#0x1234 , w2 ;
mov
w2 , [w1]
;
;Write a Double - word to the selected location
mov
#0x1122 , w2
mov
#0x4455 , w3
mov.d w2 , [w1]
;2 EDS writes
 2010 Microchip Technology Inc.
DS39969B-page 73