PIC24FJ256DA210 Datasheet, PDF (307/408 Pages) Microchip Technology – 64/100-Pin, 16-Bit Flash Microcontrollers with Graphics Controller and USB On-The-Go (OTG)

PIC24FJ256DA210 FAMILY
REGISTER 22-3: G1CON1: DISPLAY CONTROL REGISTER 1
R/W-0
U-0
R/W-0
R/W-0
R/W-0
R/W-0
R/W-0
R/W-0
G1EN
—
G1SIDL GCMDWMK4 GCMDWMK3 GCMDWMK2 GCMDWMK1 GCMDWMK0
bit 15
bit 8
R/W-0
PUBPP2
bit 7
R/W-0
PUBPP1
R/W-0
PUBPP0
R-0, HSC
GCMDCNT4
R-0, HSC
GCMDCNT3
R-0, HSC
GCMDCNT2
R-0, HSC
GCMDCNT1
R-0, HSC
GCMDCNT0
bit 0
Legend:
R = Readable bit
-n = Value at POR
HSC = Hardware Settable/Clearable bit
W = Writable bit
U = Unimplemented bit, read as ‘0’
‘1’ = Bit is set
‘0’ = Bit is cleared
x = Bit is unknown
bit 15
bit 14
bit 13
bit 12-8
bit 7-5
bit 4-0
G1EN: Module Enable bit
1 = Display module is enabled
0 = Display module is disabled
Unimplemented: Read as ‘0’
G1SIDL: Stop in Idle bit
1 = Display module stops in Idle mode
0 = Display module does not stop in Idle mode
GCMDWMK<4:0>: Command FIFO Watermark bits
Sets the command watermark level that triggers the CMDLVIF interrupt and sets the CMDLV flag;
GCMDWMK<4:0> (10000 = Reserved)
10000 = If the number of commands present in the FIFO goes from 16 to 15 commands, the CMDLVIF
interrupt will trigger and the CMDLV flag will be set
01111 = f the number of commands present in the FIFO goes from 15 to 14 commands, CMDLVIF
interrupt will trigger and CMDLV flag will be set
.
.
.
00001 = If the number of commands present in the FIFO goes from 1 to 0 commands, the CMDLVIF
interrupt will trigger and the CMDLV flag will be set
00000 = CMDLVIF interrupt will not trigger and the CMDLV flag will not be set
PUBPP<2:0>: GPU bits-per-pixel (bpp) Setting bits
Other = Reserved
100 = 16 bits-per-pixel
011 = 8 bits-per-pixel
010 = 4 bits-per-pixel
001 = 2 bits-per -pixel
000 = 1-bit -per-pixel
GCMDCNT<4:0>: Command FIFO Occupancy Status bits
When the FIFO is full, any additional commands written to the FIFO are discarded.
10000 = 16 commands are present in the FIFO
01111 = 15 commands are present in the FIFO
.
.
.
0001 = 1 command is present in the FIFO
0000 = 0 command is present in the FIFO
 2010 Microchip Technology Inc.
DS39969B-page 307