PIC24FJ256DA210 Datasheet, PDF (256/408 Pages) Microchip Technology – 64/100-Pin, 16-Bit Flash Microcontrollers with Graphics Controller and USB On-The-Go (OTG)

PIC24FJ256DA210 FAMILY
REGISTER 18-4: U1OTGCON: USB ON-THE-GO CONTROL REGISTER
U-0
U-0
U-0
U-0
U-0
U-0
U-0
—
—
—
—
—
—
—
bit 15
U-0
—
bit 8
R/W-0
DPPULUP
bit 7
R/W-0
R/W-0
R/W-0
R/W-0
DMPULUP DPPULDWN⁽¹⁾ DMPULDWN⁽¹⁾ VBUSON⁽¹⁾
R/W-0
OTGEN⁽¹⁾
R/W-0
VBUSCHG⁽¹⁾
R/W-0
VBUSDIS⁽¹⁾
bit 0
Legend:
R = Readable bit
-n = Value at POR
W = Writable bit
‘1’ = Bit is set
U = Unimplemented bit, read as ‘0’
‘0’ = Bit is cleared
x = Bit is unknown
bit 15-8
bit 7
bit 6
bit 5
bit 4
bit 3
bit 2
bit 1
bit 0
Unimplemented: Read as ‘0’
DPPULUP: D+ Pull-up Enable bit
1 = D+ data line pull-up resistor is enabled
0 = D+ data line pull-up resistor is disabled
DMPULUP: D- Pull-up Enable bit
1 = D- data line pull-up resistor is enabled
0 = D- data line pull-up resistor is disabled
DPPULDWN: D+ Pull-Down Enable bit⁽¹⁾
1 = D+ data line pull-down resistor is enabled
0 = D+ data line pull-down resistor is disabled
DMPULDWN: D- Pull-Down Enable bit⁽¹⁾
1 = D- data line pull-down resistor is enabled
0 = D- data line pull-down resistor is disabled
VBUSON: VBUS Power-on bit⁽¹⁾
1 = VBUS line is powered
0 = VBUS line is not powered
OTGEN: OTG Features Enable bit⁽¹⁾
1 = USB OTG is enabled; all D+/D- pull-up and pull-down bits are enabled
0 = USB OTG is disabled; D+/D- pull-up and pull-down bits are controlled in hardware by the settings
of the HOSTEN and USBEN (U1CON<3,0>) bits
VBUSCHG: VBUS Charge Select bit⁽¹⁾
1 = VBUS line is set to charge to 3.3V
0 = VBUS line is set to charge to 5V
VBUSDIS: VBUS Discharge Enable bit⁽¹⁾
1 = VBUS line is discharged through a resistor
0 = VBUS line is not discharged
Note 1: These bits are only used in Host mode; do not use in Device mode.
DS39969B-page 256
 2010 Microchip Technology Inc.