PIC24FJ256DA210 Datasheet, PDF (374/408 Pages) Microchip Technology – 64/100-Pin, 16-Bit Flash Microcontrollers with Graphics Controller and USB On-The-Go (OTG)

PIC24FJ256DA210 FAMILY
TABLE 30-4: DC CHARACTERISTICS: OPERATING CURRENT (IDD)
DC CHARACTERISTICS
Standard Operating Conditions: 2.2V to 3.6V (unless otherwise stated)
Operating temperature -40°C  TA  +85°C for Industrial
Parameter
No.
Typical⁽¹⁾
Max
Units
Conditions
Operating Current (IDD)⁽²⁾
DC20D
0.8
1.3
mA
DC20E
0.8
1.3
mA
DC20F
0.8
1.3
mA
-40°C
+25°C
+85°C
3.3V⁽³⁾
1 MIPS
DC23D
DC23E
3.0
4.8
mA
3.0
4.8
mA
-40°C
+25°C
3.3V⁽³⁾
4 MIPS
DC23F
3.0
4.8
mA
+85°C
DC24D
DC24E
12.0
18
mA
12.0
18
mA
-40°C
+25°C
3.3V⁽³⁾
16 MIPS
DC24F
12.0
18
mA
+85°C
DC31D
DC31E
DC31F
Note 1:
2:
3:
55
95
A
55
95
A
-40°C
+25°C
3.3V⁽³⁾
LPRC (31 kHz)
135
225
A
+85°C
Data in “Typical” column is at 3.3V, 25°C unless otherwise stated. Parameters are for design guidance only
and are not tested.
The supply current is mainly a function of the operating voltage and frequency. Other factors, such as I/O pin
loading and switching rate, oscillator type, internal code execution pattern and temperature, also have an
impact on the current consumption. The test conditions for all IDD measurements are as follows: OSCI driven
with external square wave from rail to rail. All I/O pins are configured as inputs and pulled to VDD. MCLR = VDD;
WDT and FSCM are disabled. CPU, SRAM, program memory and data memory are operational. No peripheral
modules are operating and all of the Peripheral Module Disable (PMD) bits are set.
On-chip voltage regulator enabled (ENVREG tied to VDD). Brown-out Reset (BOR) is enabled.
DS39969B-page 374
 2010 Microchip Technology Inc.