PIC24FJ256DA210 Datasheet, PDF (195/408 Pages) Microchip Technology – 64/100-Pin, 16-Bit Flash Microcontrollers with Graphics Controller and USB On-The-Go (OTG)

PIC24FJ256DA210 FAMILY
REGISTER 12-2: TyCON: TIMER3 AND TIMER5 CONTROL REGISTER⁽³⁾
R/W-0
U-0
R/W-0
U-0
U-0
U-0
U-0
TON⁽¹⁾
—
TSIDL⁽¹⁾
—
—
—
—
bit 15
U-0
—
bit 8
U-0
—
bit 7
R/W-0
R/W-0
R/W-0
U-0
TGATE⁽¹⁾ TCKPS1⁽¹⁾ TCKPS0⁽¹⁾
—
U-0
R/W-0
U-0
—
TCS^(1,2)
—
bit 0
Legend:
R = Readable bit
-n = Value at POR
W = Writable bit
‘1’ = Bit is set
U = Unimplemented bit, read as ‘0’
‘0’ = Bit is cleared
x = Bit is unknown
bit 15
bit 14
bit 13
bit 12-7
bit 6
bit 5-4
bit 3-2
bit 1
bit 0
TON: Timery On bit⁽¹⁾
1 = Starts 16-bit Timery
0 = Stops 16-bit Timery
Unimplemented: Read as ‘0’
TSIDL: Stop in Idle Mode bit⁽¹⁾
1 = Discontinue module operation when device enters Idle mode
0 = Continue module operation in Idle mode
Unimplemented: Read as ‘0’
TGATE: Timery Gated Time Accumulation Enable bit⁽¹⁾
When TCS = 1:
This bit is ignored.
When TCS = 0:
1 = Gated time accumulation enabled
0 = Gated time accumulation disabled
TCKPS<1:0>: Timery Input Clock Prescale Select bits⁽¹⁾
11 = 1:256
10 = 1:64
01 = 1:8
00 = 1:1
Unimplemented: Read as ‘0’
TCS: Timery Clock Source Select bit^(1,2)
1 = External clock from pin, TyCK (on the rising edge)
0 = Internal clock (FOSC/2)
Unimplemented: Read as ‘0’
Note 1:
2:
3:
When 32-bit operation is enabled (T2CON<3> or T4CON<3> = 1), these bits have no effect on Timery
operation; all timer functions are set through T2CON and T4CON.
If TCS = 1, RPINRx (TxCK) must be configured to an available RPn/RPIn pin. See Section 10.4 “Peripheral
Pin Select (PPS)” for more information.
Changing the value of TyCON while the timer is running (TON = 1) causes the timer prescale counter to
reset and is not recommended.
 2010 Microchip Technology Inc.
DS39969B-page 195