English
Language : 

PIC24FJ256DA210 Datasheet, PDF (345/408 Pages) Microchip Technology – 64/100-Pin, 16-Bit Flash Microcontrollers with Graphics Controller and USB On-The-Go (OTG)
PIC24FJ256DA210 FAMILY
REGISTER 26-1: CTMUCON: CTMU CONTROL REGISTER
R/W-0
CTMUEN
bit 15
U-0
R/W-0
R/W-0
R/W-0
—
CTMUSIDL TGEN(1)
EDGEN
R/W-0
EDGSEQEN
R/W-0
IDISSEN
R/W-0
CTTRIG
bit 8
R/W-0
EDG2POL
bit 7
R/W-0
EDG2SEL1
R/W-0
EDG2SEL0
R/W-0
EDG1POL
R/W-0
EDG1SEL1
R/W-0
EDG1SEL0
R/W-0, HSC
EDG2STAT
R/W-0, HSC
EDG1STAT
bit 0
Legend:
R = Readable bit
-n = Value at POR
HSC = Hardware Settable/Clearable bit
W = Writable bit
U = Unimplemented bit, read as ‘0’
‘1’ = Bit is set
‘0’ = Bit is cleared
x = Bit is unknown
bit 15
bit 14
bit 13
bit 12
bit 10
bit 10
bit 9
bit 8
bit 7
bit 6-5
bit 4
CTMUEN: CTMU Enable bit
1 = Module is enabled
0 = Module is disabled
Unimplemented: Read as ‘0’
CTMUSIDL: Stop in Idle Mode bit
1 = Discontinue module operation when the device enters Idle mode
0 = Continue module operation in Idle mode
TGEN: Time Generation Enable bit(1)
1 = Enables edge delay generation
0 = Disables edge delay generation
EDGEN: Edge Enable bit
1 = Edges are not blocked
0 = Edges are blocked
EDGSEQEN: Edge Sequence Enable bit
1 = Edge 1 event must occur before Edge 2 event can occur
0 = No edge sequence is needed
IDISSEN: Analog Current Source Control bit
1 = Analog current source output is grounded
0 = Analog current source output is not grounded
CTTRIG: Trigger Control bit
1 = Trigger output is enabled
0 = Trigger output is disabled
EDG2POL: Edge 2 Polarity Select bit
1 = Edge 2 is programmed for a positive edge response
0 = Edge 2 is programmed for a negative edge response
EDG2SEL<1:0>: Edge 2 Source Select bits
11 = CTEDG1 pin
10 = CTEDG2 pin
01 = OC1 module
00 = Timer1 module
EDG1POL: Edge 1 Polarity Select bit
1 = Edge 1 is programmed for a positive edge response
0 = Edge 1 is programmed for a negative edge response
Note 1: If TGEN = 1, the peripheral inputs and outputs must be configured to an available RPn/RPIn pin. See
Section 10.4 “Peripheral Pin Select (PPS)” for more information.
 2010 Microchip Technology Inc.
DS39969B-page 345