PIC24FJ256DA210 Datasheet, PDF (376/408 Pages) Microchip Technology – 64/100-Pin, 16-Bit Flash Microcontrollers with Graphics Controller and USB On-The-Go (OTG)

PIC24FJ256DA210 FAMILY
TABLE 30-6: DC CHARACTERISTICS: POWER-DOWN CURRENT (IPD)
DC CHARACTERISTICS
Standard Operating Conditions: 2.2V to 3.6V (unless otherwise stated)
Operating temperature -40°C  TA  +85°C for Industrial
Parameter
No.
Typical⁽¹⁾
Max
Units
Conditions
Power-Down Current (IPD)⁽²⁾
DC60D
20.0
45
A
-40°C
DC60E
DC60H
20.0
45
55.0
105
A
+25°C
3.3V⁽³⁾ Base power-down current⁽⁴⁾
A
+60°C
DC60F
95.0
185
A
+85°C
DC61D
1.0
3.5
A
-40°C
DC61E
DC61H
1.0
1.0
3.5
3.5
A
A
+25°C
+60°C
3.3V⁽³⁾
31 kHz LPRC oscillator with
RTCC, WDT or Timer1:ILPRC⁽⁴⁾
DC61F
2.5
6.5
A
+85°C
DC62D
DC62E
DC62H
DC62F
1.5
6
A
-40°C
1.5
1.5
6
6
A
A
+25°C
+60°C
3.3V⁽³⁾
Low drive strength, 32 kHz crystal
with RTCC or Timer1: ISOSC;
SOSCSEL<1:0> = 01⁽⁴⁾
8.0
18
A
+85°C
DC63D
DC63E
DC63H
DC63F
4.0
18
4.0
18
6.5
18
12.0
25
A
-40°C
A
A
+25°C
+60°C
3.3V⁽³⁾
32 kHz crystal
with RTCC or Timer1: ISOSC;
SOSCSEL<1:0> = 11⁽⁴⁾
A
+85°C
Note 1: Data in the Typical column is at 3.3V, 25°C unless otherwise stated. Parameters are for design guidance
only and are not tested.
2: Base IPD is measured with the device in Sleep mode (all peripherals and clocks are shut down). All I/Os
are configured as inputs and pulled high. WDT, etc., are all switched off, PMSLP bit is clear and the
Peripheral Module Disable (PMD) bits for all unused peripherals are set.
3: On-chip voltage regulator enabled (ENVREG tied to VDD). Brown-out Reset (BOR) is enabled.
4: The  current is the additional current consumed when the module is enabled. This current should be
added to the base IPD current.
DS39969B-page 376
 2010 Microchip Technology Inc.