PIC24FJ256DA210 Datasheet, PDF (263/408 Pages) Microchip Technology – 64/100-Pin, 16-Bit Flash Microcontrollers with Graphics Controller and USB On-The-Go (OTG)

PIC24FJ256DA210 FAMILY
REGISTER 18-13: U1CNFG2: USB CONFIGURATION REGISTER 2
U-0
U-0
U-0
U-0
U-0
U-0
U-0
U-0
—
—
—
—
—
—
—
—
bit 15
bit 8
U-0
—
bit 7
U-0
R/W-0
R/W-0
R/W-0
R/W-0
R/W-0
R/W-0
—
UVCMPSEL _{PUVBUS EXTI2CEN UVBUSDIS}⁽¹⁾ _UVCMPDIS⁽¹⁾ _UTRDIS⁽¹⁾
bit 0
Legend:
R = Readable bit
-n = Value at POR
W = Writable bit
‘1’ = Bit is set
U = Unimplemented bit, read as ‘0’
‘0’ = Bit is cleared
x = Bit is unknown
bit 15-6
bit 5
bit 4
bit 3
bit 2
bit 1
bit 0
Unimplemented: Read as ‘0’
UVCMPSEL: VBUS Comparator External Interface Selection bit
1 = Use VBUSVLD, SESSVLD and SESSEND as comparator interface pins
0 = Use VCMPST1 and VCMPST2 as comparator interface pins
PUVBUS: VBUS Pull-Up Enable bit
1 = Pull-up on VBUS pin is enabled
0 = Pull-up on VBUS pin is disabled
EXTI2CEN: I²C™ Interface For External Module Control Enable bit
1 = External module(s) is controlled via the I²C™ interface
0 = External module(s) controlled via the dedicated pins
UVBUSDIS: On-Chip 5V Boost Regulator Builder Disable bit⁽¹⁾
1 = On-chip boost regulator builder is disabled; digital output control interface is enabled
0 = On-chip boost regulator builder is active
UVCMPDIS: On-Chip VBUS Comparator Disable bit⁽¹⁾
1 = On-chip charge VBUS comparator is disabled; digital input status interface is enabled
0 = On-chip charge VBUS comparator is active
UTRDIS: On-Chip Transceiver Disable bit⁽¹⁾
1 = On-chip transceiver is disabled; digital transceiver interface is enabled
0 = On-chip transceiver is active
Note 1: Never change these bits while the USBPWR bit is set (U1PWRC<0> = 1).
 2010 Microchip Technology Inc.
DS39969B-page 263