S9S12G128F0CLF Datasheet, PDF (411/1158 Pages) Freescale Semiconductor, Inc – MC9S12G Family Reference Manual

Analog-to-Digital Converter (ADC10B12CV2)
12.3.2.11 ATD Compare Higher Than Register (ATDCMPHT)
Writes to this register will abort current conversion sequence.
Read: Anytime
Write: Anytime
Module Base + 0x000E
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
0
R0
0
0
0
W
CMPHT[11:0]
Reset 0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
= Unimplemented or Reserved
Figure 12-13. ATD Compare Higher Than Register (ATDCMPHT)
Table 12-20. ATDCMPHT Field Descriptions
Field
Description
11–0
Compare Operation Higher Than Enable for conversion number n (n= 11, 10, 9, 8, 7, 6, 5, 4, 3, 2, 1, 0) of
CMPHT[11:0] a Sequence (n conversion number, NOT channel number!) — This bit selects the operator for comparison
of conversion results.
0 If result of conversion n is lower or same than compare value in ATDDRn, this is flagged in ATDSTAT2
1 If result of conversion n is higher than compare value in ATDDRn, this is flagged in ATDSTAT2
12.3.2.12 ATD Conversion Result Registers (ATDDRn)
The A/D conversion results are stored in 12 result registers. Results are always in unsigned data
representation. Left and right justification is selected using the DJM control bit in ATDCTL3.
If automatic compare of conversions results is enabled (CMPE[n]=1 in ATDCMPE), these registers must
be written with the compare values in left or right justified format depending on the actual value of the
DJM bit. In this case, as the ATDDRn register is used to hold the compare value, the result will not be
stored there at the end of the conversion but is lost.
Attention, n is the conversion number, NOT the channel number!
Read: Anytime
Write: Anytime
NOTE
For conversions not using automatic compare, results are stored in the result
registers after each conversion. In this case avoid writing to ATDDRn except
for initial values, because an A/D result might be overwritten.
12.3.2.12.1 Left Justified Result Data (DJM=0)
MC9S12G Family Reference Manual, Rev.1.10
Freescale Semiconductor
411