MC68HC908KX8 Datasheet, PDF (211/310 Pages) Motorola, Inc – Microcontrollers

Serial Communications Interface Module (SCI)
I/O Registers
14.8.6 SCI Data Register
The SCI data register (SCDR) is the buffer between the internal data bus
and the receive and transmit shift registers. Reset has no effect on data
in the SCI data register.
Address: $0018
Bit 7
6
5
4
3
2
1
Bit 0
Read: R7
R6
R5
R4
R3
R2
R1
R0
Write: T7
T6
T5
T4
T3
T2
T1
T0
Reset:
Unaffected by reset
Figure 14-15. SCI Data Register (SCDR)
R7/T7–R0/T0 — Receive/Transmit Data Bits
Reading address $0018 accesses the read-only received data bits,
R7–R0. Writing to address $0018 writes the data to be transmitted,
T7–T0. Reset has no effect on the SCI data register.
NOTE: Do not use read-modify-write instructions on the SCI data register.
14.8.7 SCI Baud Rate Register
The baud rate register (SCBR) selects the baud rate for both the receiver
and the transmitter.
Address: $0019
Bit 7
6
5
4
3
2
1
Read: 0
Write:
0
SCP1 SCP0
R
SCR2 SCR1
Reset: 0
0
0
0
0
0
0
= Unimplemented
R = Reserved
Figure 14-16. SCI Baud Rate Register (SCBR)
Bit 0
SCR0
0
SCP1 and SCP0 — SCI Baud Rate Prescaler Bits
These read/write bits select the baud rate prescaler divisor as shown
in Table 14-6. Reset clears SCP1 and SCP0.
MC68HC908KX8 • MC68HC908KX2 • MC68HC08KX8 — Rev. 1.0
MOTOROLA
Serial Communications Interface Module (SCI)
Technical Data
211