PIC18F67J11-IPT Datasheet, PDF (394/448 Pages) Microchip Technology – 64/80-Pin High-Performance, 1-Mbit Flash Microcontrollers with nanoWatt Technology

PIC18F87J11 FAMILY
27.2 DC Characteristics: Power-Down and Supply Current
PIC18F87J11 Family (Industrial) (Continued)
PIC18F87J11 Family
(Industrial)
Standard Operating Conditions (unless otherwise stated)
Operating temperature
-40°C ≤ TA ≤ +85°C for industrial
Param
No.
Device
Typ Max Units
Conditions
Supply Current (IDD) Cont.^(2,3)
All devices 18 35 µA
19 35 µA
28 49 µA
-40°C
+25°C
+85°C
VDD = 2.0V,
VDDCORE = 2.0V⁽⁴⁾
All devices 20 45 µA
21 45 µA
32 61 µA
-40°C
+25°C
+85°C
VDD = 2.5V,
VDDCORE = 2.5V⁽⁴⁾
FOSC = 32 kHz⁽³⁾
(SEC_RUN mode,
Timer1 as clock)
All devices 0.06 0.11 mA
0.07 0.11 mA
-40°C
+25°C
VDD = 3.3V⁽⁵⁾
0.09 0.15 mA
+85°C
All devices 14 28 µA
15 28 µA
24 43 µA
-40°C
+25°C
+85°C
VDD = 2.0V,
VDDCORE = 2.0V⁽⁴⁾
All devices 15 31 µA
16 31 µA
27 50 µA
-40°C
+25°C
+85°C
VDD = 2.5V,
VDDCORE = 2.5V⁽⁴⁾
FOSC = 32 kHz⁽³⁾
(SEC_IDLE mode,
Timer1 as clock)
All devices 0.05 0.10 mA
0.06 0.10 mA
-40°C
+25°C
VDD = 3.3V⁽⁵⁾
0.08 0.14 mA
+85°C
Note 1:
2:
3:
4:
5:
The power-down current in Sleep mode does not depend on the oscillator type. Power-down current is measured with
the part in Sleep mode, with all I/O pins in high-impedance state and tied to VDD or VSS and all features that add delta
current disabled (such as WDT, Timer1 oscillator, BOR, etc.).
The supply current is mainly a function of operating voltage, frequency and mode. Other factors, such as I/O pin loading
and switching rate, oscillator type and circuit, internal code execution pattern and temperature, also have an impact on
the current consumption.
The test conditions for all IDD measurements in active operation mode are:
OSC1 = external square wave, from rail-to-rail; all I/O pins tri-stated, pulled to VDD;
MCLR = VDD; WDT enabled/disabled as specified.
Standard, low-cost 32 kHz crystals have an operating temperature range of -10°C to +70°C. Extended temperature
crystals are available at a much higher cost.
Voltage regulator disabled (ENVREG = 0, tied to VSS).
Voltage regulator enabled (ENVREG = 1, tied to VDD, REGSLP = 1).
DS39778D-page 394
© 2009 Microchip Technology Inc.