PIC18F67J11-IPT Datasheet, PDF (154/448 Pages) Microchip Technology – 64/80-Pin High-Performance, 1-Mbit Flash Microcontrollers with nanoWatt Technology

PIC18F87J11 FAMILY
11.1 Module Registers
The PMP module has a total of 14 Special Function
Registers for its operation, plus one additional register
to set configuration options. Of these, 8 registers are
used for control and 6 are used for PMP data transfer.
11.1.1 CONTROL REGISTERS
The eight PMP Control registers are:
• PMCONH and PMCONL
• PMMODEH and PMMODEL
• PMSTATL and PMSTATH
• PMEH and PMEL
The PMCON registers (Register 11-1 and
Register 11-2) control basic module operations, includ-
ing turning the module on or off. They also configure
address multiplexing and control strobe configuration.
The PMMODE registers (Register 11-3 and
Register 11-4) configure the various Master and Slave
Operating modes, the data width and interrupt
generation.
The PMEH and PMEL registers (Register 11-5 and
Register 11-6) configure the module’s operation at the
hardware (I/O pin) level.
The PMSTAT registers (Register 11-7 and
Register 11-8) provide status flags for the module’s
input and output buffers, depending on the operating
mode.
REGISTER 11-1: PMCONH: PARALLEL PORT CONTROL HIGH BYTE REGISTER
R/W-0
U-0
PMPEN
—
bit 7
R/W-0
PSIDL
R/W-0
R/W-0
ADRMUX1 ADRMUX0
R/W-0
PTBEEN
R/W-0
PTWREN
R/W-0
PTRDEN
bit 0
Legend:
R = Readable bit
-n = Value at POR
W = Writable bit
‘1’ = Bit is set
U = Unimplemented bit, read as ‘0’
‘0’ = Bit is cleared
x = Bit is unknown
bit 7
bit 6
bit 5
bit 4-3
bit 2
bit 1
bit 0
PMPEN: Parallel Master Port Enable bit
1 = PMP enabled
0 = PMP disabled, no off-chip access performed
Unimplemented: Read as ‘0’
PSIDL: Stop in Idle Mode bit
1 = Discontinue module operation when device enters Idle mode
0 = Continue module operation in Idle mode
ADRMUX1:ADRMUX0: Address/Data Multiplexing Selection bits
11 = Reserved
10 = All 16 bits of address are multiplexed on PMD<7:0> pins
01 = Lower 8 bits of address are multiplexed on PMD<7:0> pins, upper 8 bits are on PMA<15:8>
00 = Address and data appear on separate pins
PTBEEN: Byte Enable Port Enable bit (16-bit Master mode)
1 = PMBE port enabled
0 = PMBE port disabled
PTWREN: Write Enable Strobe Port Enable bit
1 = PMWR/PMENB port enabled
0 = PMWR/PMENB port disabled
PTRDEN: Read/Write Strobe Port Enable bit
1 = PMRD/PMWR port enabled
0 = PMRD/PMWR port disabled
DS39778D-page 154
© 2009 Microchip Technology Inc.