ZAMC4100 Datasheet, PDF (15/155 Pages) Integrated Device Technology – Actuator and Motor Controller

ZAMC4100 Datasheet
Table 1.3 ESD Protection
Test Method
Test Setup Standard
Guaranteed ESD/Latch-up
Robustness on IC Level
HBM (Human Body Model)
MIL 883C, Method 3015.7
or EIA/JESD22A114-A
± 2kV (all pins) with 100pF and 1.5kΩ
CDM (Charged Device Model)
System Level (Human Body Discharge)
AEC – Q100 – 011 Rev. B
IEC 61000-4-2
± 500V (all pins)
± 6kV for LIN⁽¹⁾ and VBAT⁽²⁾
Latch-up
EIA/JESD78A
100mA@25˚C
(1) External circuitry is required for meeting the system-level ESD specification for the LIN interface.
(2) VBAT is the common supply terminal on the application PCB where all ZAMC4100 supply pins are connected.
1.2. Electrical Parameters
Note: Parameters are specified for junction temperature range -40°C to 125°C unless otherwise stated.
1.2.1. Supply and Supply Monitoring
Table 1.4 Supply Voltages and Currents
Parameter
Supply Voltage Range (voltage drop in external circuitry not included)
Nominal operating voltage
LIN operating voltage
Supply Current Range
NORMAL Mode
STANDBY Mode
SLEEP Mode (measured at TJ=27°C; VSUP=13V through all VSS pins)
Switchable Analog Supply Voltage (to S_P pin)
Voltage range (S_P pin unloaded)
Voltage range (S_P pin loaded with 5mA)
Nominal output current
Current limitation in case of short to GND
GPIO Supply Voltage
Voltage range
Symbol
VSUP
VSUP_LIN
IRUN
ISTBY
ISLEEP
VSP
VSP_5mA
ISP
ISP_OC
VGPIO
Min. Typ. Max. Unit
6
-
18
V
7
-
18
V
-
14
-
mA
-
10
-
mA
-
-
80
µA
4.5
5
5.5
V
3.8
4.5
5.2
V
0
-
5
mA
6
-
9
mA
2.97 3.3 3.63
V
© 2016 Integrated Device Technology, Inc.
15
January 26, 2016