MB86290A Datasheet, PDF (87/184 Pages) Fujitsu Component Limited. – Graphics Controller Hardware Specifications

DrawLine2iP (Format7)
31
24 23
16 15
DrawLine2iP
Draw Command
LFYs
Reserved
LFXs
0
Vertex
Draws Fast2Dline
Start drawing after setting parameters at Fast2DLIne draw registers. Only
packed integer data can be used for vertices.
Commands:
ZeroVector
OneVector
ZeroVectorNoEnd
OneVectorNoEnd
ZeroVectorBlpClear
OneVectorBlpClear
ZeroVectorNoEndBlpClear
OneVectorNoEndBlpClear
AntiZeroVector
AntiOneVector
AntiZeroVectorNoEnd
AntiOneVectorNoEnd
AntiZeroVectorBlpClear
AntiOneVectorBlpClear
AntiZeroVectorNoEndBlpClear
AntiOneVectorNoEndBlpClear
Draw line from vertex 0 to vertex 1.
Draw line from vertex 1 to vertex 0.
Draw line without end point from vertex 0 to vertex 1
Draw line without end point from vertex 1 to vertex 0
Draw line from vertex 0 to vertex 1.
Prior to drawing, clear the reference position of the broken line pattern.
Draw line from vertex 1 to vertex 0.
Prior to drawing, clear reference position of broken line pattern.
Draw line from vertex 0 to vertex 1 without end point.
Prior to drawing, clear reference position of broken line pattern.
Draw line from vertex 1 to vertex 0 without end point.
Prior to drawing, clear reference position of te broken line pattern.
Draw anti-alias line from vertex 0 to vertex 1.
Draw anti-alias line from vertex 1 to vertex 0.
Draw anti-alias line without end point from vertex 0 to vertex 1.
Draw anti-alias line without end point from vertex 1 to vertex 0.
Draw anti-alias line from vertex 0 to vertex 1.
Prior to drawing, clear reference position of broken line pattern.
Draw anti-alias line from vertex 1 to vertex 0.
Prior to drawing, clear reference position of broken line pattern.
Draw anti-alias line from vertex 0 to vertex 1 without end point.
Prior to drawing, clear reference position of broken line pattern.
Draw anti-alias line from vertex 1 to vertex 0 without end point.
Prior to drawing, clear reference position of broken line pattern.
87