MB86290A Datasheet, PDF (85/184 Pages) Fujitsu Component Limited. – Graphics Controller Hardware Specifications

DrawLine (Format5)
31
24 23
16 15
0
DrawLine
Draw Command
Reserved
LPN
LXs
LXde
LYs
LYde
Draws line
Start drawing after setting all parameters at line draw registers.
Commands:
Xvector
Yvector
XvectorNoEnd
YvectorNoEnd
XvectorBlpClear
YvectorBlpClear
XvectorNoEndBlpClear
YvectorNoEndBlpClear
AntiXvector
AntiYvector
AntiXvectorNoEnd
AntiYvectorNoEnd
AntiXvectorBlpClear
AntiYvectorBlpClear
AntiXvectorNoEndBlpClear
AntiYvectorNoEndBlpClear
Draw line (*1).
Draw line (*2).
Draw line without end point (*1).
Draw line without end point (*2).
Draw line (*1).
Prior to drawing, clear reference position of broken line pattern.
Draw a line (*2)
Prior to drawing, clear reference position of broken line pattern.
Draw line without end point (*1).
Prior to drawing, clear reference position of broken line pattern.
Draw line without end point (*2).
Prior to drawing, clear reference position of broken line pattern.
Draw anti-alias line (*1).
Draw anti-alias line (*2).
Draw anti-alias line without end point (*1).
Draw anti-alias line without end point (*2).
Draw anti-alias line (*1).
Prior to drawing, clear reference position of broken line pattern.
Draw anti-alias line (*2).
Prior to drawing, clear reference position of broken line pattern.
Draw anti-alias line without end point (*1).
Prior to drawing, clear reference position of broken line pattern.
Draw anti-alias line without end point (*2).
Prior to drawing, clear reference position of broken line pattern
Note
(*1) -Pai/4 ” Line angle ” Pai/4
Pai/2
(*2) -Pai/2 ” Line angle ” -Pai/4, orPai/4 ” Line angle ”
85