MC68HC08GZ32 Datasheet, PDF (281/320 Pages) Freescale Semiconductor, Inc – Microcontrollers

Break Module (BRK)
BRKA — Break Active Bit
This read/write status and control bit is set when a break address match occurs. Writing a 1 to BRKA
generates a break interrupt. Clear BRKA by writing a 0 to it before exiting the break routine. Reset
clears the BRKA bit.
1 = Break address match
0 = No break address match
20.2.2.2 Break Address Registers
The break address registers (BRKH and BRKL) contain the high and low bytes of the desired breakpoint
address. Reset clears the break address registers.
Address: $FE09
Bit 7
6
5
4
3
2
1
Bit 0
Read:
Bit 15
Bit 14
Bit 13
Bit 12
Bit 11
Bit 10
Bit 9
Bit 8
Write:
Reset: 0
0
0
0
0
0
0
0
Figure 20-5. Break Address Register High (BRKH)
Address: $FE0A
Bit 7
6
5
4
3
2
1
Bit 0
Read:
Bit 7
Bit 6
Bit 5
Bit 4
Bit 3
Bit 2
Bit 1
Bit 0
Write:
Reset: 0
0
0
0
0
0
0
0
Figure 20-6. Break Address Register Low (BRKL)
20.2.2.3 Break Status Register
The break status register (BSR) contains a flag to indicate that a break caused an exit from wait mode.
This register is only used in emulation mode.
Address: $FE00
Bit 7
6
5
4
3
2
1
Bit 0
Read:
SBSW
R
Write:
R
R
R
R
R
Note⁽¹⁾
R
Reset:
R = Reserved
0
1. Writing a 0 clears SBSW.
Figure 20-7. Break Status Register (BSR)
SBSW — SIM Break Stop/Wait
SBSW can be read within the break state SWI routine. The user can modify the return address on the
stack by subtracting one from it.
1 = Wait mode was exited by break interrupt
0 = Wait mode was not exited by break interrupt
MC68HC08GZ32 Data Sheet, Rev. 3
Freescale Semiconductor
281