MC68HC08GZ32 Datasheet, PDF (140/320 Pages) Freescale Semiconductor, Inc – Microcontrollers

MSCAN08 Controller (MSCAN08)
RXF — Receive Buffer Full
The RXF flag is set by the MSCAN08 when a new message is available in the foreground receive
buffer. This flag indicates whether the buffer is loaded with a correctly received message. After the
CPU has read that message from the receive buffer the RXF flag must be cleared to release the buffer.
A set RXF flag prohibits the exchange of the background receive buffer into the foreground buffer. If
not masked, a receive interrupt is pending while this flag is set.
1 = The receive buffer is full. A new message is available.
0 = The receive buffer is released (not full).
NOTE
To ensure data integrity, no registers of the receive buffer shall be read
while the RXF flag is cleared.
The CRFLG register is held in the reset state when the SFTRES bit in
CMCR0 is set.
12.13.6 MSCAN08 Receiver Interrupt Enable Register
Address: $0505
Bit 7
6
5
4
3
2
1
Bit 0
Read:
WUPIE
Write:
RWRNIE TWRNIE
RERRIE
TERRIE
BOFFIE
OVRIE
RXFIE
Reset: 0
0
0
0
0
0
0
0
Figure 12-21. Receiver Interrupt Enable Register (CRIER)
WUPIE — Wakeup Interrupt Enable
1 = A wakeup event will result in a wakeup interrupt.
0 = No interrupt will be generated from this event.
RWRNIE — Receiver Warning Interrupt Enable
1 = A receiver warning status event will result in an error interrupt.
0 = No interrupt is generated from this event.
TWRNIE — Transmitter Warning Interrupt Enable
1 = A transmitter warning status event will result in an error interrupt.
0 = No interrupt is generated from this event.
RERRIE — Receiver Error Passive Interrupt Enable
1 = A receiver error passive status event will result in an error interrupt.
0 = No interrupt is generated from this event.
TERRIE — Transmitter Error Passive Interrupt Enable
1 = A transmitter error passive status event will result in an error interrupt.
0 = No interrupt is generated from this event.
BOFFIE — Bus-Off Interrupt Enable
1 = A bus-off event will result in an error interrupt.
0 = No interrupt is generated from this event.
OVRIE — Overrun Interrupt Enable
1 = An overrun event will result in an error interrupt.
0 = No interrupt is generated from this event.
MC68HC08GZ32 Data Sheet, Rev. 3
140
Freescale Semiconductor