MC68HC08GZ32 Datasheet, PDF (26/320 Pages) Freescale Semiconductor, Inc – Microcontrollers

General Description
1.5.11 Port D I/O Pins (PTD7/T2CH1–PTD0/SS)
PTD7–PTD0 are special-function, bidirectional I/O port pins. PTD3–PTD0 can be programmed to be
serial peripheral interface (SPI) pins, while PTD7–PTD4 can be individually programmed to be timer
interface module (TIM1 and TIM2) pins. PTD0 can be used to output a clock, MCLK. PTD7 is only
available on the 48-pin LQFP and 64-pin QFP packages. See Chapter 18 Timer Interface Module (TIM1),
Chapter 19 Timer Interface Module (TIM2), Chapter 16 Serial Peripheral Interface (SPI) Module, Chapter
13 Input/Output (I/O) Ports, and Chapter 5 Mask Options.
These port pins also have selectable pullups when configured for input mode. The pullups are disengaged
when configured for output mode. The pullups are selectable on an individual port bit basis.
1.5.12 Port E I/O Pins (PTE5–PTE0/TxD)
PTE5–PTE0 are general-purpose, bidirectional I/O port pins. PTE1 and PTE0 can also be programmed
to be enhanced serial communications interface (ESCI) pins. See Chapter 14 Enhanced Serial
Communications Interface (ESCI) Module and Chapter 13 Input/Output (I/O) Ports.
1.5.13 Port F I/O Pins (PTF7/T2CH5–PTF0)
PTF7–PTF4 are special-function, bidirectional I/O port pins that can be individually programmed to be
timer interface module (TIM2) pins.
PTF3–PTF0 are general-purpose, bidirectional I/O port pins that contain higher current sink/source
capability.
PTF7–PTF0 are only available on the 64-pin QFP package. See Chapter 19 Timer Interface Module
(TIM2) and Chapter 13 Input/Output (I/O) Ports.
1.5.14 Port G I/O Pins (PTG7/AD23–PTBG0/AD16)
PTG7–PTG0 are general-purpose, bidirectional I/O port pins that can also be used for analog-to-digital
converter (ADC) inputs. PTG7–PTG0 are only available on the 64-pin QFP package. See Chapter 13
Input/Output (I/O) Ports and Chapter 3 Analog-to-Digital Converter (ADC).
1.6 Unused Pin Termination
Input pins and I/O port pins that are not used in the application must be terminated. This prevents excess
current caused by floating inputs, and enhances immunity during noise or transient events. Termination
methods include:
1. Configuring unused pins as outputs and driving high or low;
2. Configuring unused pins as inputs and enabling internal pull-ups;
3. Configuring unused pins as inputs and using external pull-up or pull-down resistors.
Never connect unused pins directly to V_DD or V_SS.
Since some general-purpose I/O pins are not available on all packages, these pins must be terminated
as well. Either method 1 or 2 above are appropriate.
MC68HC08GZ32 Data Sheet, Rev. 3
26
Freescale Semiconductor