MC68HC08GZ32 Datasheet, PDF (214/320 Pages) Freescale Semiconductor, Inc – Microcontrollers

System Integration Module (SIM)
15.6.2 Stop Mode
In stop mode, the SIM counter is reset and the system clocks are disabled. An interrupt request from a
module can cause an exit from stop mode. Stacking for interrupts begins after the selected stop recovery
time has elapsed. Reset also causes an exit from stop mode.
The SIM disables the clock generator module outputs (CGMOUT and CGMXCLK) in stop mode, stopping
the CPU and peripherals. Stop recovery time is selectable using the SSREC bit in the mask option register
(MOR). If SSREC is set, stop recovery is reduced from the normal delay of 4096 CGMXCLK cycles down
to 32. This is ideal for applications using canned oscillators that do not require long startup times from
stop mode.
NOTE
External crystal applications should use the full stop recovery time by
clearing the SSREC bit unless OSCENINSTOP bit is set in MOR2.
The SIM counter is held in reset from the execution of the STOP instruction until the beginning of stop
recovery. It is then used to time the recovery period. Figure 15-20 shows stop mode entry timing. Figure
15-21 shows stop mode recovery time from interrupt.
NOTE
To minimize stop current, all pins configured as inputs should be driven to
a logic 1 or logic 0.
CPUSTOP
IAB
STOP ADDR
STOP ADDR + 1
SAME
SAME
IDB
PREVIOUS DATA
NEXT OPCODE
SAME
SAME
R/W
Note: Previous data can be operand data or the STOP opcode, depending on the last instruction.
Figure 15-20. Stop Mode Entry Timing
CGMXCLK
INT/BREAK
IAB
STOP RECOVERY PERIOD
STOP +1
STOP + 2 STOP + 2
SP
SP – 1
SP – 2
SP – 3
Figure 15-21. Stop Mode Recovery from Interrupt
MC68HC08GZ32 Data Sheet, Rev. 3
214
Freescale Semiconductor