EP2SGX30C Datasheet, PDF (72/314 Pages) Altera Corporation – Stratix II GX Device

MultiTrack Interconnect
The direct link interconnect allows a LAB, DSP block, or TriMatrix
memory block to drive into the local interconnect of its left and right
neighbors and then back into itself, providing fast communication
between adjacent LABs and/or blocks without using row interconnect
resources.
The R4 interconnects span four LABs, three LABs and one M512 RAM
block, two LABs and one M4K RAM block, or two LABs and one DSP
block to the right or left of a source LAB. These resources are used for fast
row connections in a four-LAB region. Every LAB has its own set of R4
interconnects to drive either left or right. Figure 2–46 shows R4
interconnect connections from a LAB.
R4 interconnects can drive and be driven by DSP blocks and RAM blocks
and row IOEs. For LAB interfacing, a primary LAB or LAB neighbor can
drive a given R4 interconnect. For R4 interconnects that drive to the right,
the primary LAB and right neighbor can drive onto the interconnect. For
R4 interconnects that drive to the left, the primary LAB and its left
neighbor can drive onto the interconnect. R4 interconnects can drive
other R4 interconnects to extend the range of LABs they can drive. R4
interconnects can also drive C4 and C16 interconnects for connections
from one row to another. Additionally, R4 interconnects can drive R24
interconnects.
Figure 2–46. R4 Interconnect Connections Notes (1), (2), (3)
R4 Interconnect
Driving Left
Adjacent LAB can
Drive onto Another
LAB's R4 Interconnect
C4 and C16
Column Interconnects (1)
R4 Interconnect
Driving Right
LAB
Neighbor
Primary
LAB (2)
LAB
Neighbor
Notes to Figure 2–46:
(1) C4 and C16 interconnects can drive R4 interconnects.
(2) This pattern is repeated for every LAB in the LAB row.
(3) The LABs in Figure 2–46 show the 16 possible logical outputs per LAB.
2–64
Stratix II GX Device Handbook, Volume 1
Altera Corporation
October 2007