W83627DHG Datasheet, PDF (92/268 Pages) Winbond – WINBOND LPC I/O

W83627DHG
0: SMI# output type is in Two-Times Interrupt mode. (Default)
Bit 5:
1: SMI# output type of temperature SYSTIN is One-Time Interrupt mode.
0: SMI# output type is Two-Times Interrupt mode.
Bit 4:
1: Disable temperature sensor AUXTIN over-temperature (OVT) output. (Default)
0: Enable
AUXTIN OVT output through pin OVT#.
Bit 3:
1: Disable temperature sensor CPUTIN over-temperature (OVT) output.
0: Enable
CPUTIN OVT output through pin OVT#. (Default)
Bit 2: Over-temperature polarity.
1: OVT# active high.
0: OVT# active low. (Default)
Bit 1-0: Reserved.
8.43 FAN IN/OUT Control Register - Index 4Dh (Bank 0)
Register Location:
4Dh
Power on Default Value:
95h
Attribute:
Read/Write
Size:
8 bits
7 6 5432 1 0
FANINC1
FANOPV1
FANINC2
FANOPV2
FANINC3
FANOPV3
Reserved
Reserved
Bit 7-6: Reserved.
Bit 5: AUXFANIN0 output value, only if bit 4 is set to zero.
1: Pin111 (AUXFANIN0) generates a logic-high signal.
0: Pin111 generates a logic-low signal. (Default)
Bit 4: AUXFANIN0 Input Control.
1: Pin111 (AUXFANIN0) acts as a FAN tachometer input. (Default)
0: Pin111 acts as a FAN control signal, and the output value is set by bit 5.
Bit 3: CPUFANIN0 output value, only if bit 2 is set to zero.
1: Pin112 (CPUFANIN0) generates a logic-high signal.
0: Pin112 generates a logic-low signal. (Default)
Bit 2: CPUFANIN0 Input Control.
1: Pin112 (CPUFANIN0) acts as a FAN tachometer input. (Default)
0: Pin112 acts as a FAN control signal, and the output value is set by bit 3.
Publication Release Date: Aug, 22, 2007
-80-
Version 1.4