W83627DHG Datasheet, PDF (3/268 Pages) Winbond – WINBOND LPC I/O

W83627DHG
Data Sheet Revision History
PAGES DATES
1 N.A. 12/15/2005
2 N.A. 02/22/2006
3 N.A. 03/15/2006
4 N.A. 05/05/2006
5 N.A 05/15/2006
6 N.A. 05/19/2006
7 N.A. 06/23/2006
VERSION
0.1
0.2
0.3
0.4
0.41
0.42
0.5
WEB
VERSION
MAIN CONTENTS
N.A. 1. First published version.
N.A.
1. Add descriptions of the registers, functions,, AC/DC
timing, and top marking
1. Revise Table 8.1 and the timing chart of section 10.3.1
2. Add registers for AMDSI at LDB, CRF5h,CRF6h and
F7h(Bank1)
3. Swap LDB, CRF2h bit 0 and bit 1.
N.A. 4. Modify the default values for LDA, CRFEh
5. Modify the descriptions of LD9, CR30h bit 0 and
CRF7h bit 4.
6. Remove LDA, CRE9h bit4 ~ 3
7. Swap LDC, CRE0h bit3~0 and CRE5h bit7~4
1. Add FDC, UART, Parallel Port and KBC interface
descriptions
2. Remove all the descriptions about AMDSI
3. Modify the diagrams and descriptions for Current Mode
4. Add two control bits for the selections of SYSFANOUT
and CPUFANOUT0 output type at CR[24h]
N.A. 5. Remove the description of the internal pulled-up
resistor of Parallel Port
6. Modify the definitions of edge/level and enable/disable
debounce circuit of GP30, GP31 and GP35
7. Modify the descriptions of LD7, CRF7h and LD9,
CRE6h ~ CRE9h
8. Correct typos and grammatical mistakes
N.A
1. Remove the remaining descriptions about AMDSI in
datasheet ver.0.4
1. Add a note for Index# of FDC Interface and pin
83(GP42) of Serial Port & Infrared Port Interface in Pin
Description
2. Reserve the bit 7 of LD0, CRF0h
N.A 3. Modify the descriptions of TRAK0#, WP#, RDATA#
and DSKCHG# of FDC Interface
4. Modify the descriptions for strapping pins: HEFRAS,
PENROM, PENKBC and EN_GTL
5. Modify the DC spec.
1. Remove the note and renew the descriptions for
Index# of FDC Interface.
2. Correct the descriptions of HM Device Bank 0, CR[12h]
N.A.
bit0.
3. Add two control bits for AUXFANOUT and
CPUFAOUT1 output type selection.
4. Add a new bit at LDC, CR[E8h] bit 1 for more PECI
Publication Release Date: Aug, 22, 2007
-I-
Version 1.4